Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
These Amerock #5 x 1/2-inch flat head screws in Satin Nickel are installation hardware designed to mount cabinet knobs, pulls, and decorative hardware where a finish-matched fastener keeps the look clean and consistent. The flat head seats flush against the mounting surface, and the Phillips drive works with any standard #2 bit.
These screws are sized and finished for attaching Amerock decorative hardware to cabinet doors and drawer fronts. The 1/2-inch length is suited to typical cabinet door and drawer front stock, where the screw needs to anchor securely into the panel without over-penetrating. A finish-matched screw matters most in installations where the hardware plate or base is partially visible, such as backplates, cup pulls, and surface-mount knobs where the fastener head can be seen at close range.
The Satin Nickel finish on these screws is chosen to coordinate with Amerock hardware sold in the same finish. Steel construction keeps the screw strong enough for repeated tightening without stripping under normal installation torque. The flat head countersinks cleanly into most cabinet substrates, leaving a low-profile seating surface behind the hardware plate.
Cabinet installers, finish carpenters, and homeowners replacing or installing Amerock hardware will find these screws useful when the original fasteners are missing or when a finish-consistent replacement is needed. Shops specifying Amerock hardware across a full cabinet run can use these to keep every visible fastener in the same finish family without sourcing a generic substitute.
These are Amerock-sourced installation screws finished to match Amerock hardware. The #5 gauge and 1/2-inch length may fit other brands' hardware mounting holes, but finish coordination is optimized for Amerock Satin Nickel products.
A standard #2 Phillips bit drives these screws. No specialty tooling is needed.
These screws are sourced from Amerock and finished in Satin Nickel to coordinate with Amerock hardware in the same finish. As with any finish match, lighting conditions and surface wear can affect appearance over time.
These are steel screws intended for interior cabinet hardware installation. They are not rated for exterior or high-humidity environments.
When the hardware finish matters, the fastener finish should too. These Amerock Satin Nickel flat head screws let installers and homeowners complete the hardware installation without a visible mismatch at the mounting point.