Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Quickscrews 6.3mm x 10mm flat head euro screw is a short-reach fastener for installing European cup hinges, drawer slides, and other 32mm system hardware into the pre-bored holes of cabinet side panels. At 10mm, it is sized specifically for standard cabinet panel thicknesses where full thread engagement is needed without punching through the back face.
Euro screws are the standard fastener for attaching hinge mounting plates, drawer slide brackets, and shelf hardware to the interior faces of frameless and face-frame cabinets. They drive into the 5mm-diameter line-bore holes of the 32mm system, or into the stepped pilot holes required by 6.3mm confirmat applications. The 10mm length is the go-to choice when the combined panel and hardware stack is shallow enough that a longer screw would risk breaking through the outer face of the cabinet side. Kitchen cabinet boxes built from 3/4-inch particleboard or MDF are the most common application, but this length also works for furniture panels, shop-built carcasses, and any European-style assembly where a short, reliable hold is the goal.
The nickel finish gives these screws a neutral, low-profile appearance against white or light-colored cabinet interiors, and it holds up to the humidity cycles typical in kitchen and bath environments. The flat countersunk head sits flush with or just below the hardware mounting plate, so nothing stands proud to interfere with hinge adjustability or drawer slide travel. Pozidriv #2 is the preferred drive for European cabinetry fasteners because its parallel flanks resist cam-out under the repeated, moderate torque of production assembly. A correctly sized PZ2 bit will seat fully in the recess and transfer torque evenly, reducing head damage across a full box of 100 screws.
This box of 100 suits shops and installers who go through euro screws in volume: building kitchen or bath cabinet runs, installing commercial casework, or setting up furniture for flat-pack assembly. The blunt point and coarse thread work together in pre-bored pilot holes, so each screw drops in and drives without fuss. Keeping a supply of the correct length on hand means no mid-job substitutions that can strip a hinge plate or over-penetrate a thin panel side.
A 3/4-inch panel is about 19mm thick. At 10mm, the screw engages the panel fully through the hardware mounting plate while staying well short of the outer face, so there is no risk of a visible exit point on the cabinet exterior.
Yes. The blunt point is designed for pre-bored holes, not for self-starting in unprepared material. Drill the correct pilot hole for a 6.3mm euro screw before driving.
A Phillips bit will fit physically but will cam out under load because its tapered flanks do not match the parallel walls of the Pozidriv recess. Use a PZ2 Pozidriv bit for clean, damage-free driving.
The coarse thread grips reliably in particleboard, MDF, and melamine-faced panels, which are the standard substrates in European-style cabinet construction. They are not intended for solid hardwood without a pre-drilled clearance hole.
European cup hinges, undermount and side-mount drawer slides, shelf hardware, and other 32mm system components that use pre-bored mounting holes in the cabinet panel face.
When the job calls for reliable hardware mounting in standard cabinet panels without any risk of breakthrough, the Quickscrews 6.3mm x 10mm euro screw gives you the correct reach, a flush-seating flat head, and a Pozidriv drive that stays engaged from first contact to final torque.
Sold In: 1 Each