Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Sugatsune 26 Series pull is a stainless steel bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
A 5-1/16 inch center-to-center pull lands on mid-width drawers and standard upper door fronts, the two most common locations in a kitchen hardware program. At that spacing the pull is proportioned for a 12 to 18 inch drawer front without overpowering it, and it sits comfortably on a door where a shorter pull would look undersized. In a design program that asks for a single pull size across drawers and doors, 128 mm is often the choice that works at both scales without compromise.
The slim 9/16 inch bar section keeps the hardware reading as a line rather than an object on the front, which suits flat-panel and slab cabinetry where the hardware should underscore the geometry rather than interrupt it.
The 26 Series pull is made from stainless steel, which means the base material and the finish surface are the same metal rather than a plated coating over a different substrate. On a bar pull that sees daily hand contact, that matters: there is no plating layer to wear through at the grip point, and the surface holds its appearance with routine cleaning. The finish name, Stainless Steel, is an accurate description of what the pull is made of, not a coating applied over zinc or aluminum. In kitchens and baths where the adjacent fixtures, appliances, and sinks are already stainless, this pull reads as part of the same material family rather than an approximation of it.
Cabinet shops and designers running a contemporary or transitional kitchen in stainless reach for the 26 Series when the project calls for hardware that coordinates with professional-style appliances and stainless sinks without a visible finish mismatch. The 128 mm spacing is straightforward for a shop drilling a standard two-hole pattern, and the pull's consistent dimension across a run makes it efficient to install in volume. Homeowners replacing hardware on an existing drawer bank drilled to 5-1/16 inch centers get a direct swap without additional drilling. The slim bar profile also suits vanities and built-ins where the hardware needs to read clean rather than decorative.
The pull is constructed from stainless steel, so the material and the finish are the same. There is no separate plating layer over a different base metal.
The 5-1/16 inch (128 mm) measurement is the distance between the centers of the two mounting holes. The pull itself measures 7-1/2 inches end to end, which is larger. Match your existing holes to the 5-1/16 inch figure, not the overall length.
At 9/16 inch (14 mm) across, the bar is slim by design. It provides a secure grip for normal cabinet and drawer use while keeping a linear, low-profile look on the front.
The Sugatsune 26 Series includes other center-to-center sizes in the same bar profile and Stainless Steel finish, so a consistent look across different drawer and door widths is achievable within the series.
For a kitchen or bath program that needs a stainless bar pull at the standard 128 mm drilling, the 26 Series at 5-1/16 inch centers delivers the material integrity and the clean profile to carry that work without compromise.
