Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune 2653-S is a contemporary stainless steel bar pull from the 26 Series, designed for cabinet doors and drawer fronts where 13-7/16 inch (342 mm) center-to-center mounting is required.
A 13-7/16 inch center-to-center pull belongs on a front that deserves it. Wide base drawers, deep drawer stacks, pantry doors, and full-height cabinet fronts are the natural applications: surfaces wide enough that a shorter pull looks undersized and the hand needs a longer grip to open the front cleanly. At 16 inches overall, this pull scales to those fronts without overwhelming a door or looking heavy against the cabinetry. Designers applying a proportional approach to pull sizing will find this spacing suited to fronts in the 36 to 48 inch range, though that is a preference rather than a specification.
The pull is made from stainless steel and carries a Stainless Steel finish, meaning the material and the surface read as one. There is no plating, no tinted coating, and no color applied over a different substrate. The result is a consistent silver-tone surface that does not wear through to a contrasting base material. On a slim 9/16 inch bar, the finish catches light evenly along the length of the grip, which suits kitchens and baths where adjacent stainless fixtures and appliances are already setting the metal tone of the room.
This pull fits naturally into a contemporary or transitional kitchen where the cabinetry runs wide and the hardware program is stainless or silver-tone throughout. Cabinet shops building large island drawers and appliance garages, designers specifying coordinated hardware across a full kitchen, and contractors fitting out commercial or high-spec residential kitchens will find the 342 mm spacing useful for fronts that would look under-hardwared with a shorter pull. Because it belongs to the Sugatsune 26 Series, companion pulls in other center-to-center sizes are available in the same profile and finish for consistency across a mixed cabinet layout.
Center-to-center is the distance between the two mounting holes, 13-7/16 inches (342 mm), and is the measurement that must match your existing holes or your planned drill pattern. Overall length is 16 inches (406 mm), which is larger and describes how much of the door or drawer front the pull spans visually.
A pantry or tall cabinet door is one of the most common applications for a pull at this center-to-center spacing. The length provides a natural grip point at door height without requiring the hand to reach for a shorter pull.
This pull carries a Stainless Steel finish over a stainless steel base, so the surface tone is consistent with most stainless appliances. Finish appearance can vary between manufacturers, so comparing the pull against your appliances before final installation is the best approach.
Yes. The Sugatsune 26 Series includes pulls at multiple center-to-center spacings in the same profile and finish, so you can run consistent hardware across different cabinet widths in one layout.
When the drawer or door front calls for a pull that matches its scale, the 13-7/16 inch center-to-center spacing of this Sugatsune 26 Series bar pull delivers a grip that fits the front and a finish that works with the room.
