Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune 26 Series pull is a contemporary stainless steel bar pull sized for large cabinet doors and wide drawer fronts, mounting on 19-3/8 inch (492 mm) centers.
A 19-3/8 inch center-to-center pull belongs on fronts where a shorter pull would look undersized and out of proportion. Wide pantry doors, tall upper cabinet doors, deep drawer banks, and large island drawers are the situations this span is built to serve. At nearly 22 inches end to end, the pull draws a long horizontal line across the front, which anchors the door visually and gives the hand a wide grip zone to work with. The narrow 9/16 inch bar keeps that line lean rather than heavy, so the hardware registers as a detail rather than a statement piece even on a large front.
This pull is machined and finished in stainless steel, and the material runs through the entire piece rather than sitting as a coating over a different base. Stainless holds its appearance without plating to wear through, and the brushed surface keeps the finish even under kitchen or bath light without picking up glare. The silver tone integrates naturally with stainless appliances, sinks, and fixtures already present in most kitchens, which is why this finish requires no coordination work when the room is already running stainless.
This pull suits any high-specification kitchen, commercial-adjacent workspace, or butler's pantry where the hardware program is stainless and the cabinetry runs large. Cabinet shops and designers specifying a full kitchen will find the 26 Series consistent in profile across multiple center-to-center sizes, so mixing spans within one project keeps the hardware reading as a system rather than a collection of separate pulls. Contractors fitting out hospitality or light commercial spaces will appreciate the material consistency across the series for exactly the same reason.
Measure from the center of one mounting hole to the center of the other. This pull requires holes set 19-3/8 inches (492 mm) apart.
The Material Type is stainless steel, meaning the construction is stainless throughout, not a plated coating over another base metal.
Yes. The 26 Series is available in multiple spans, so you can run a consistent bar profile across doors and drawers of different widths within the same project.
At nearly 22 inches overall, it suits oversized doors, tall upper cabinets, wide pantry fronts, and large deep drawers where a shorter pull would look proportionally small.
When the front is wide and the hardware program is stainless, this 26 Series pull covers the span cleanly and holds the look of the series across the rest of the kitchen.
