Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a pre-cut 1/4 inch drawer bottom panel from Genesis, sized at 13.18 inches wide by 16.38 inches deep (335mm x 416mm) to fit the corresponding Genesis drawer system box. It slides into the grooved sides of a Genesis drawer box, completing the box so it is ready for installation on its slides.
A drawer bottom is the last structural piece in a grooved-side drawer box. The Genesis system drawer sides are machined with a groove near the bottom edge; this panel slides into that groove during assembly, before the back goes on. Once seated, it closes the box floor and keeps the box square under load. Because the dimensions are pre-cut to this system's spec, the panel drops straight in without resawing or trimming — a meaningful time-saver when building a run of boxes to the same nominal length.
If you are replacing a damaged bottom in an existing Genesis box, match the panel dimensions to what came out: 13.18 inches wide and 16.38 inches deep at 1/4 inch thick. A panel even a few millimeters off will not seat fully in the groove or will rock in an oversized opening.
The panel material is not specified in the available source data. Genesis drawer system components are typically panel board or plywood stock at 1/4 inch nominal thickness, but the exact substrate, core, and face finish for this SKU are not confirmed. If material and surface finish matter for your application — for example if the drawer bottom will be visible inside a display cabinet or needs to match an interior color — verify the substrate with the product listing's spec block or contact the supplier before ordering.
Cabinet shops running Genesis drawer boxes will use this bottom when building new boxes from system components, or when a bottom is damaged and needs to be swapped without rebuilding the full box. Because the dimensions are system-matched rather than a cut-to-size blank, it suits production environments where a specific Genesis nominal length repeats across many cabinets in a job. Custom shops building one-off boxes in non-standard depths will need to source a panel and cut to fit instead.
It is sized for the Genesis system box. Drawer sides from other brands — Blum TANDEMBOX, Grass Nova Pro Scala, KV, and others — each carry their own groove dimensions and bottom-panel cutting formulas. A panel cut for Genesis dimensions may not seat correctly in a non-Genesis side. Use this panel with Genesis system sides.
One panel per drawer box. A drawer box has one bottom, regardless of whether it runs on a pair of side-mount slides or a single undermount runner.
Technically a panel can be trimmed, but a Genesis system box built to the published spec should accept this panel without cutting. If your box dimensions differ from the Genesis nominal spec for this length, you may be working from a non-standard box or a different nominal size — confirm your box's cutting dimensions against the Genesis spec sheet before ordering.
The 335mm x 416mm (13.18 x 16.38 inch) dimensions correspond to a specific Genesis system nominal length. Check the Genesis drawer system component list for your nominal length and confirm this bottom's part number appears as the matching bottom panel for that configuration.
A correctly seated drawer bottom is what holds a glued or screwed box in square during and after assembly. This pre-cut Genesis panel removes one measuring and cutting step from the box-building process, keeping production moving without the risk of a mis-cut floor panel that racks the box before it ever hits the slides.
Sold In: 1 Each
