Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a 1/4-inch drawer bottom panel from the Genesis drawer system, cut to 335mm x 568mm (approximately 13-3/16 inches x 22-3/8 inches) to fit the system's 24-inch nominal-length drawer boxes. It supplies the bottom closure for a Genesis box build without requiring the shop to cut, measure, or source sheet material separately.
The drawer bottom is the last panel to go in before the back closes the box. On a Genesis system build, the bottom slides into the groove near the lower edge of each drawer side and seats flush. Because Genesis side profiles are engineered to accept a 1/4-inch bottom at a specific groove position, using a panel cut to the published formula keeps the box square and the bottom seated properly. This panel is cut to that formula for a 24-inch nominal-length box, so it arrives dimensioned for the job rather than needing a trim pass.
The panel is 1/4-inch thick, consistent with standard drawer bottom construction across the Genesis program. Material composition beyond panel thickness is not stated in the source data for this SKU. If finish, species, or substrate information is critical to your build process, confirm with the product spec sheet before ordering. The panel dimensions — 335mm wide by 568mm long — are drawn from the system's published cutting formula for the 24-inch nominal length, so the fit to the groove and the box interior is engineered rather than approximate.
Cabinet shops running Genesis drawer systems in production benefit most from ordering bottoms as system-matched components rather than sizing them from a sheet. Designers and contractors specifying Genesis box builds can call this panel out by nominal length so the installer receives pre-sized parts. For renovation work where a Genesis bottom panel has been damaged or lost, this SKU provides a direct replacement at the correct dimension without measuring a compromised box. It is an indoor, dry-environment panel suited to standard kitchen, bath, closet, and office casework.
This panel is cut to Genesis system dimensions. Other brands publish their own bottom cutting formulas, and a panel sized for Genesis may not seat correctly in a Blum, Grass, Hettich, or other system's drawer sides. Use system-matched bottoms for each platform.
The 568mm length corresponds to the Genesis 24-inch nominal-length box. If your boxes are a different nominal length, select the bottom panel sized for that length in the Genesis program.
This is a drawer bottom component cut to a specific system formula. It is not sized or rated for general shelf or cabinet bottom applications.
No. The groove is machined into the drawer side profiles; this panel slides into that groove. The bottom panel itself is a flat panel, not pre-grooved.
A panel cut to spec is one fewer variable on the build. Order by nominal length, match it to your Genesis sides, and the bottom goes in straight the first time.
Sold In: 1 Each
