Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Genesis miter fold drawer box delivers a clean, jointless corner profile and a factory-applied white finish in a wide, shallow format that suits full-width kitchen and bath drawers, base cabinet pull-outs, and any application where a low drawer height and broad span matter most.
A 7-inch side height paired with a 22.95-inch width is the combination that works in wide, single-drawer base cabinets — the kind found under cooktops, in bathroom vanities, and in entry-furniture consoles where the opening is generous left to right but shallow top to bottom. The 13.77-inch depth keeps the box out of the way of base-cabinet plumbing rough-ins and rear stretchers without sacrificing the working interior. Cabinet shops running a consistent white interior finish across a run of uppers and lowers will find the factory-applied finish eliminates an in-shop step and keeps the color consistent between custom-built boxes and Genesis components.
Miter-fold construction wraps the panel material around the corner at a mitered angle, bonding it into a closed, seamless profile rather than interlocking finger joints or an exposed dovetail. The result is a drawer exterior that reads as a single flat surface on each face, which matters when the box rides on an undermount slide and the sides are visible to anyone looking inside the cabinet. The white finish is applied at the factory, so the box ships ready to pair with white melamine drawer bottoms and matching interiors. Confirm the bottom panel dimensions against the Genesis cutting specification for this nominal size before cutting stock.
This box works best for cabinet shops and contractors who specify white interiors across a project and want a finished drawer box that arrives ready to install without an additional finishing step. Homeowners completing a single vanity or kitchen island pull-out will appreciate the same benefit: the finish is already done, the size is fixed, and the only task is fitting the box to the slide and attaching the front. At 22.95 inches wide, this is not a box for narrow 12-inch base cabinets — it is sized for the wider bays where a standard 18-inch box would rattle around with excessive side play.
The bottom panel is not confirmed as included in the source data. Build or cut the bottom to the Genesis dimensional specification for this box size and verify the groove position before cutting.
The appropriate slide type depends on the cabinet construction and the runner system specified for your project. Undermount slides sized to the box depth and side thickness are the common pairing for a miter-fold box at this width; confirm compatibility with the slide manufacturer's box specification.
Yes, but face-frame installations may require rear mounting brackets depending on the slide system chosen. Check the slide manufacturer's face-frame requirements before ordering slides and hardware.
The box ships with a factory-applied white finish. Exact color matching to a specific melamine sheet good is not guaranteed without a sample comparison, as white tones vary across manufacturers.
The Genesis miter fold drawer box in this wide, shallow format cuts one step from the shop process — the finish is done, the corners are clean, and the box is built to spec so it drops straight onto the slide and takes the front.
Sold In: 1 Each
