Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Omega National CO2 Series tambour door covers a 30-inch-wide appliance garage opening with a flat-profile maple wood veneer panel, supplied unfinished so it can be stained or painted to integrate with the surrounding cabinetry.
A 30-inch tambour door is the right choice when the appliance garage spans the width of a base or wall cabinet that needs to conceal a toaster oven, coffee station, or similar countertop appliance. The flexible slat panel rolls along the track to open and close the garage, and the flat profile keeps the closed face unobtrusive. At 18 inches tall, it works across typical appliance garage heights without custom cutting.
The slats are faced in maple wood veneer, which produces a consistent grain pattern across the full panel width. Maple takes stain evenly, so the door can be matched to painted or stained cabinets with standard finishing materials. Because the panel ships unfinished, the finish is applied on-site after installation, which means the tambour integrates with the rest of the kitchen rather than arriving as a visual mismatch. The 1/2-inch depth is appropriate for the CO2 track system; confirm track compatibility before ordering if you are sourcing the track separately.
Cabinet shops and finish carpenters building or refacing kitchen cabinetry with an appliance garage will find this panel most useful when the opening is 30 inches wide and the finish has not yet been committed. Designers specifying a custom kitchen where all surfaces need to coordinate can call this door out knowing the finish will be site-applied. Homeowners doing a targeted cabinet refresh with a wider appliance garage can use this panel to replace a worn or missing door. The tambour track and mounting hardware are not included with the door panel and are ordered separately.
No. This SKU is the tambour door panel only. The track, mounting hardware, and any carcase components are sold separately. Make sure the track you are using is compatible with a 30-inch-wide, 1/2-inch-deep CO2 panel.
No. The panel is unfinished maple wood veneer. Apply your stain, paint, or clear coat after installation to match the surrounding cabinetry.
The veneer panel is 1/2 inch deep and uses a maple veneer face over a substrate, which tends to give a very consistent grain and surface. The solid wood version is 3/16 inch deep and uses solid maple throughout. Both are unfinished; the choice usually comes down to the track system and the depth your application allows.
Tambour panels are generally not field-trimmed in width because the slat-and-backing construction does not allow a clean cut along the slat edges. If you need a narrower door, select the 15-inch or 24-inch width in this series instead.
When the appliance garage is 30 inches wide and the final finish is being decided on-site, this maple veneer tambour door gives cabinet professionals a flat-faced, stain- and paint-ready panel sized to cover the opening without track or hardware commitments built in.
Sold In: 1 Each