Maple Bottom Mount Waste Pullout for a Finished-Interior Cabinet

This Rev-A-Shelf 4WCBM waste pullout brings a 50 quart silver bin behind a base cabinet door on soft-open and soft-close slides, with a prefinished maple carriage built to show inside a cabinet where the interior matters.

Key Features

• Prefinished maple carriage delivers a clean, finished look inside the cabinet without any additional prep or painting.
• 50 quart silver bin included ships with one bin ready for use at install.
• Soft-open and soft-close slides ease the unit out and back in without slamming at either end of travel.
• Full-extension bottom mount pulls the bin completely out of the cabinet for unobstructed access and liner changes.
• 150 pound weight capacity handles a full bin plus door-mount panel weight without strain.
• Door-mount compatible so the bin rolls out when the cabinet door opens, keeping the bin hidden at rest.

Where This Pullout Earns Its Place

Most waste pullouts live inside a painted or melamine cabinet where the carriage finish is invisible. This one is built for cabinets where the interior is on display, whether that is an open-frame face-frame run, a glass-door cabinet bank, or a custom kitchen where every interior surface is finished wood. The prefinished maple carriage holds up to visual scrutiny in a way that a plain metal or white frame does not. The full-extension slides bring the 50 quart bin all the way forward so the liner can be swapped without reaching into the cabinet, and the door-mount bracket ties the bin to the cabinet door so the entire unit moves on the pull of the handle.

Build, Finish, and Motion

The carriage is maple, prefinished and ready to install without shop-finishing time. The single bin is silver, a finish that pairs naturally with the warm maple frame and with stainless or brushed hardware in the surrounding kitchen. The motion system handles both directions: soft-open eases the loaded bin outward at the start of travel, and soft-close catches it on the way back so it does not slam shut. The bottom-mount slide design keeps the hardware below the bin, leaving the top of the bin open and the liner fully accessible from above. The unit carries a 150 pound weight capacity, which covers a full 50 quart bin and a standard cabinet door panel on the door-mount bracket.

Who Specifies This Unit

Cabinet shops finishing interiors to match doors and face frames reach for this pullout when a plain carriage would read as unfinished next to the surrounding woodwork. Designers specifying a cohesive interior for a custom kitchen will find the maple carriage integrates cleanly with natural wood interiors. The minimum cabinet opening is 11-3/8 inches wide, 21-7/8 inches deep, and 23-3/16 inches tall, so measure the clear interior before ordering. The unit fits a 12-inch nominal base cabinet opening in most standard face-frame and frameless configurations that meet those minimums.

Common Questions

A Finished Interior, Right Down to the Waste Bin

Specify this pullout when the cabinet interior needs to look as considered as the exterior, and the job calls for a 50 quart bin that moves on controlled, damped slides.