Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Pro Value Series concealed hinge is built for half overlay doors on face-frame and frameless cabinets, with soft-close damping and dowel mounting built in.
Half overlay is the geometry for partial-overlap doors, and it matters most where two doors share a single center partition. Each door covers roughly half the partition width rather than the full cabinet side, and the half crank arm is what makes that clearance possible without the two arms meeting behind the doors. The 35mm cup bores into the back of the door, and the arm connects to a separate base plate mounted to the cabinet. That plate is a separate purchase and must match this hinge's brand and series. A base plate from another brand will not connect.
The dowel mount means the cup locks into the door through pre-bored dowel holes rather than screws, which keeps the door face clean and suits CNC-bored production runs where speed and consistency matter.
The hinge body is steel with a nickel finish. Because this is a concealed hinge, the finish is visible only during installation and service, not when the door is closed. The soft-close damper is the finish detail that actually shows in daily use: a door that settles quietly and consistently rather than racking against the cabinet face protects the surrounding finish over time.
Reach for this hinge in any project where two doors share a center partition and a damped close matters, whether that is a kitchen renovation with paired doors, a bath vanity, or a production run of face-frame cabinets. It fits either frameless or face-frame boxes, so a shop running both construction types can stock one SKU and adapt via the plate. For a door that covers the full cabinet side rather than a partial overlap, an full overlay hinge is the correct pick. For doors outside the standard 16 to 22mm thickness range, check the manufacturer's thick-door or thin-door options.
A full overlay door covers nearly the entire cabinet side, leaving only a narrow reveal. A half overlay door covers only part of the side, about half of a shared partition width. This hinge is sized and cranked for the half overlay position.
No. The hinge arm connects to a base plate that mounts to the cabinet, and that plate is sold separately. Use a plate matched to this series. Plates from other brands are not compatible.
The cup attaches to the door through pre-bored dowel holes rather than screws. The door needs to be bored with the correct dowel hole pattern before the hinge is pressed in.
Hinge count depends on door height and weight. General guidance puts two hinges on doors up to about 40 inches tall, three on taller doors, and one more for heavier doors. The manufacturer load table gives the exact count for a specific door.
This hinge solves the two-door partition problem cleanly: the half crank keeps arms clear, the soft-close keeps the close quiet, and the dowel mount keeps the door face uncluttered.
Sold In: 1 Each