Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rev-A-Shelf 4WCTM single-bin waste pullout mounts to the top of a face-frame base cabinet and rides full-extension slides to bring a 50 quart bin completely clear of the cabinet opening for easy access and bag changes.
Top-mount waste pullouts suit base cabinets where the floor is already occupied by plumbing, an existing drawer chassis, or other hardware. Because the carriage hangs from the top of the cabinet rather than sitting on the floor, the full depth of the cabinet interior stays open below. That makes this configuration a natural fit for sink-adjacent runs, corner base cabinets with limited floor clearance, and any layout where a bottom-mount unit would conflict with existing cabinet structure. The 50 quart bin is sized for a primary kitchen trash station rather than a small recycling bin, so this pullout works hardest in the cabinet closest to the prep area.
The carriage is finished in maple, a warm, light-toned wood finish that reads naturally alongside maple cabinetry and blends into the cabinet interior when the door is open. The single white bin contrasts cleanly against the carriage and is sized at 50 quarts, which is enough capacity to get through several days of kitchen waste before a bag change is needed. Standard full-extension slides support up to 150 pounds and pull the bin to full extension so nothing is left trapped at the back. This unit does not include soft-close motion; if a damped close is a priority, the soft-close variant in the same series is the alternative.
Cabinet shops building face-frame kitchens will find this pullout straightforward to spec: the 15-inch minimum cabinet opening width, 22-1/4-inch minimum height, and 23-1/4-inch minimum depth are the numbers to confirm against the cabinet before ordering. A single-bin configuration works well when the household or workspace sorts waste into one stream, or when the cabinet width does not support a two-bin unit. Designers specifying for a natural maple kitchen get a carriage finish that disappears into the cabinet rather than drawing attention. Contractors installing in a new build or remodel can pair this with a door-mount bracket, sold separately, to connect the bin travel to the cabinet door swing.
The minimum cabinet opening is 15 inches wide, 22-1/4 inches tall, and 23-1/4 inches deep. All three dimensions need to be confirmed for the unit to fit and operate correctly. This unit is designed for face-frame cabinet construction.
The unit is door-mount compatible, but the door-mount bracket is sold separately. Without it, the bin pulls out independently of the cabinet door.
The source does not confirm a lid is included with this configuration. Check the product listing or contact the distributor to confirm lid availability for this SKU before ordering if a covered bin is required.
Top-mount units hang from the cabinet top, leaving the cabinet floor unobstructed. This is the better choice when plumbing, a base drawer, or other hardware already occupies the floor of the cabinet.
Specify this maple top-mount pullout to fit a 15-inch face-frame base cabinet with a high-capacity single bin on full-extension slides and a finish that disappears into natural maple cabinetry.
Sold In: 1 Each
