Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The VMI Air-Pro 5071 is an exterior-mounted blower motor designed to move air from the range hood through ductwork and exhaust it outside, with the motor unit positioned away from the hood itself rather than inside it.
Positioning the blower motor outside the structure rather than inside the hood changes how the entire ventilation system performs. With the motor handling the exhaust from the exterior end of the duct run, noise from the blower stays out of the kitchen, and heat generated by the motor does not transfer back into the cooking space. This configuration is commonly specified on higher-output cooktops or in kitchens where low noise at the hood is a priority. The 753 CFM rating gives the system meaningful capacity for demanding cooking tasks without requiring the motor to sit inside a wood hood shell where heat and grease exposure would be a factor.
The 5071 connects to a 10-inch duct, which supports the airflow volume at this CFM level without restricting the draw. The stand-off design holds the exterior unit away from the wall surface, providing the clearance needed for proper operation and preventing the motor housing from sitting flush against the structure. Both the duct sizing and the stand-off geometry are part of the system design and should be accounted for when planning the duct run and the exterior penetration location.
This blower is specified for kitchens where the ductwork run terminates at an exterior-mounted motor rather than at a cap or gravity damper. It suits new construction and remodel projects where the mechanical plan calls for remote blower placement, and it pairs with wood range hood shells and compatible liners from the VMI Air-Pro line. Because the motor lives outside, it is not a replacement for an in-hood power pack: the two configurations serve different installation layouts. Match the duct path, penetration size, and exterior mounting location to this unit before finalizing the installation plan.
No. This is an exterior-mounted unit. The blower sits outside the structure, at the exterior end of the duct run, not inside the hood shell or liner.
The 5071 uses a 10-inch duct connection. Size the ductwork and exterior penetration to match before installation.
Not directly. An exterior blower and an in-hood power pack are different installation configurations. This unit is for layouts where the motor is remotely positioned outside the building.
No. This is the exterior blower motor only. The decorative wood shell and the compatible liner are separate products in the VMI Air-Pro line.
The 5071 is the right choice when the mechanical plan calls for an exterior blower location, a 10-inch duct run, and 753 CFM of ventilation capacity handled from outside the building envelope.