Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Blum CLIP top BLUMOTION hinge is built specifically for blind corner cabinet doors, bringing full overlay geometry, integrated soft-close, and a nickel finish to both frameless and face-frame applications. The 95 degree opening angle is the correct engineering for a door that must clear the adjacent cabinet run without collision.
A blind corner cabinet sits at the end of a run where one door would hit the face of the cabinet around the corner if it opened too far. The 95 degree angle on this hinge is not a restriction — it is the geometry that prevents that collision. The door opens to the clearance the situation requires and no further, which protects both the door and the adjacent cabinetry.
The 35mm cup bores into the back of the door, and the dowel mount lets the cup press directly into pre-bored 8mm dowel holes without cup screws, a setup common in CNC and production environments. The arm then clips to a separate Blum base plate on the cabinet, ordered to match your cabinet construction and door position. That plate is sold separately; the hinge alone does not complete the installation.
The hinge is plated steel in a nickel finish, a neutral tone that pairs naturally with satin nickel pulls, bar handles, and edge pulls across a kitchen or bath run. Because this is a concealed hinge, the finish is visible mainly during installation or if a door is left wide open, but choosing a consistent metal across the cabinet interior is a detail that holds up in high-end residential and specification work.
BLUMOTION soft-close is integrated into the hinge body, so no separate damper accessory is needed. The mechanism cushions the door through the last few degrees of travel, protecting the door edge and the cabinet box from repeated impact at a tight corner where slam forces tend to concentrate.
Specify this hinge wherever a full overlay door terminates a cabinet run at a blind corner, on frameless 32mm system boxes or face-frame cabinets. It suits production cabinet shops running CNC-bored doors, custom builders specifying Blum hardware throughout, and contractors installing pre-built cabinets where the end door needs to clear the turn. For standard non-corner doors in the same run, pair it with the matching full overlay CLIP top BLUMOTION hinge so the soft-close action and finish stay consistent across the project.
The 95 degree limit is intentional for blind corner doors. A full 110 degree swing would drive the door into the adjacent cabinet face. The restricted angle keeps the door within safe clearance for that corner position.
No. The hinge clips to a separate Blum base plate that mounts to the cabinet side or face frame. That plate is sold separately and should be matched to your cabinet type and construction. Use only Blum plates with this hinge; plates are not interchangeable across brands.
Dowel mounting means the cup carries pre-attached dowels that press into 8mm holes bored beside the 35mm cup hole, with no cup screws required. If your doors are CNC-bored to the dowel pattern, the cup presses in without additional hardware. If your doors are not pre-bored for dowels, choose the screw-on cup version of this hinge instead.
This hinge is engineered for blind corner positions. For the remaining doors in the run, use the standard full overlay CLIP top BLUMOTION hinge, which opens to 110 degrees and uses the same clip-on arm engagement and BLUMOTION soft-close.
This hinge solves the two problems that matter most at a blind corner: keeping the door away from the adjacent cabinet as it opens, and settling it back quietly against the box when it closes.
Sold In: 1 Each