Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Grass #6 x 5/8" modified pan head screw is purpose-built for mounting European cup hinges and drawer slides inside cabinet panels. A Phillips drive, sharp point, and coarse thread combine with the low-profile modified pan head to give installers a fast, consistent mount without over-penetrating the panel or lifting the hardware plate.
Hinge and drawer slide mounting plates are pre-drilled for a specific head profile and gauge. The modified pan head on this screw bears flat and even against the plate, distributing the clamping load without the plate tilting or the head pulling through the hole. At 5/8", the length is matched to the panel thickness common in cabinet construction — long enough to grip firmly, short enough to stop well before breaking through a 3/4" panel face. Coarse thread pulls the screw in quickly and locks it into particleboard, MDF, and plywood without stripping on the way in.
The zinc coating provides standard corrosion protection for dry indoor environments — the setting where almost all European hinge and drawer slide hardware lives. It also keeps the screw from reacting with the melamine and vinyl interiors common in production cabinetry. These screws are for interior cabinet use; outdoor or high-humidity applications call for a different fastener.
Cabinet shops running production lines benefit most from the 1,000-count pack — a single box handles a significant volume of hinge and slide mounts without restocking mid-run. Installers finishing a kitchen or bath project will find the sharp point and Phillips drive let them move from one mounting hole to the next without fuss. The screw is also a reliable match for shops specifying Grass hardware, since this is the manufacturer's own installation fastener for that system.
Yes. The #6 gauge, 5/8" length, and modified pan head are the standard spec for European cup hinge and drawer slide mounting plates across most brands. If the mounting plate was designed for a #6 screw, this one will fit.
No. The sharp point self-starts in particleboard, MDF, and plywood without pre-drilling. The mounting plate hole itself acts as a guide, so the screw goes in straight and seats cleanly.
Hinge and drawer slide mounting plates are designed to be surface-mounted, not countersunk. The modified pan head bears against the plate surface and clamps it to the panel. A countersunk head would pull through the plate hole rather than seat against it.
No. The zinc finish is rated for dry indoor use. For outdoor or high-humidity applications, choose a screw with a heavier corrosion-resistant coating.
A standard #2 Phillips bit. No specialty tooling required.
A correctly specified installation screw is one less thing to think about on the line. This Grass #6 x 5/8" modified pan head screw matches the hardware, fits the panel, and drives clean — so hinges and slides go on right the first time.
Sold In: 1 Each