Nickel Concealed Hinge for Flush Inset Doors with Dowel Mounting

This Pro Value Series concealed hinge is built for inset doors on face-frame and frameless cabinets, pairing soft-close damping with a dowel-mount cup for fast, screw-free door installation in production environments.

Key Features

• Soft-close damper slows the door through the last degrees of travel so it settles without impact.
• Inset overlay geometry positions the door flush inside the cabinet opening with an even reveal on all four sides.
• Dowel-mount cup presses into pre-bored dowel holes in the door with no cup screws required.
• Full crank arm carries the precise geometry that an inset door position demands.
• 110 degree opening delivers standard swing for everyday cabinet access.
• Nickel finish on steel construction, compatible with both face-frame and frameless boxes.

Setting a Door Flush Inside the Opening

An inset door sits inside the cabinet opening rather than over it, framed by a small, even gap on all sides. That reveal is what defines the look, and this hinge's full crank arm is shaped to hold the door in exactly that position as it swings. The 35mm cup bores into the back of the door, and the dowel-mount design means the cup presses into pre-bored holes rather than relying on cup screws, which speeds up installation on CNC-bored doors without sacrificing the firm seat the cup needs. Both face-frame and frameless cabinets are supported. A matching base plate mounts to the cabinet and the hinge arm connects to it; the plate is sold separately and should be matched to this hinge's brand and series.

Steel Build in a Nickel Finish

The hinge body is steel with a nickel finish. Inset work lives or dies on the reveal, and soft-close earns its place here for practical reasons: a door fitted tightly inside its opening takes more stress from repeated slamming than an overlay door does, since there is no cabinet face to absorb the contact. The built-in damper removes that impact from the daily cycle, which protects both the door edges and the finish over time. The 45mm boring pattern matches the standard two-hole cup layout used on most production cabinets.

Where Dowel Mounting Pays Off

Dowel mounting is the detail that makes this hinge a production-friendly choice. On a cabinet line where doors are CNC-bored with pre-drilled dowel holes, the cup presses in without cup screws, cutting per-door install time. That makes this hinge a natural fit for cabinet shops running inset programs at volume, where a faster door hang compounds across a full kitchen. It also works on face-frame runs where the shop specifies inset across multiple box sizes. For a single door or a small repair, the dowel mount works just as well; the installation is simply faster when it scales. For doors that overlay the cabinet side rather than sitting inside it, an overlay hinge is the right geometry instead.

Common Questions

Quiet Closes and Even Reveals, Door After Door

Specify this hinge when the design calls for flush inset doors, the install calls for dowel-mount speed, and the finish needs to hold up in daily use.