Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
These are Genesis Miterfold pre-cut drawer box sides — 18.5 inches wide, 5 inches tall, and 20.25 inches long — ready to fold and assemble into a finished drawer box without custom milling. They are part of the Genesis BHK Drawer System and suit shops running production on medium-depth cabinets where consistent, repeatable drawer stock saves time at the bench.
Miterfold drawer sides are designed for shops that want to skip the rip-and-miter station for standard sizes. Because the fold scores are built in, a production crew can move from flat stock to a folded, glued box in fewer steps than with site-cut lumber or plywood sides. At 20.25 inches, this length targets the deeper base cabinet range — think sink base, pantry pull-out, or utensil drawer applications where a shorter side would leave the drawer loose in the cabinet. The 5 inch height works well for the middle and lower drawer positions in a standard three-drawer base stack, where a taller side would crowd the adjacent drawer fronts.
Genesis Miterfold sides are manufactured to the tolerances of the BHK Drawer System. The Miterfold process uses pre-scored panels that fold to a precise miter corner, giving the finished box a clean outside edge without exposed end grain at the joints. Material specifics — species, core construction, finish, and groove position — are not stated in the available product data. Shops integrating these sides into an existing Genesis program should confirm groove position and bottom reveal against the system's published cutting specification before running production quantities.
Cabinet shops running Genesis BHK system drawers in medium-depth base cabinets are the primary buyer for this length. A 20.25 inch drawer side suits a cabinet with a nominal 21 inch depth — a common dimension in kitchen base runs. Designers and contractors specifying drawer systems by the box may use these to standardize a single side height and length across a full kitchen, reducing the number of SKUs on a purchase order. Homeowners undertaking a DIY cabinet build can use Miterfold sides to avoid the precision milling that square-corner drawer boxes require.
The 18.5 inch figure is the flat panel width before folding. After the Miterfold corners are formed, the finished interior width of the assembled box will be smaller. Check the Genesis system specification for the finished box dimension this panel produces.
These sides are part of the Genesis BHK Drawer System and are designed to work within that program. Pairing them with slides or locking devices from other systems is not supported by the source data — use Genesis system components for a confirmed fit.
Groove position and dimensions are not confirmed in the available product data. Verify the groove spec against the Genesis BHK cutting guide before committing to a production run.
The sold-as unit is not specified in the product data. Check the quantity shown in the cart to confirm whether the price reflects a single side or a pair before ordering.
For shops standardizing on a 20-inch cabinet depth, these pre-cut Miterfold sides remove a milling variable from the drawer box process — the fold scores are set, the length is done, and the height is consistent piece to piece. That repeatability is where production time is actually recovered.
Sold In: 1 Each
