Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
These Genesis Miterfold pre-cut drawer box sides give cabinet shops a ready-to-assemble solution for mid-depth drawer runs. Each set arrives cut to 18-1/2 inches wide, 17-1/4 inches long, and 5 inches tall, with mitered corners factory-machined so the box folds together cleanly without additional shaping at the bench.
The 17-1/4 inch length is the right call for mid-depth base cabinets where the interior running depth lands in the 18 to 19 inch range. It pairs with undermount or side-mount slides specified at 17 or 18 inch nominal — check your slide manufacturer's box-length formula, because undermount slides in particular require the drawer box to be built to a published dimension, not simply cut to the slide's nominal length. This side height of 5 inches works well in stacked drawer banks and standard kitchen drawer configurations where a taller pot-drawer profile is not needed.
The Miterfold name describes the construction method: the panel is pre-scored and mitered at the corners so it folds into a box without a separate dovetail or box-joint operation. The material is not specified in the source data for this SKU — confirm the substrate (Baltic birch plywood or engineered board), groove specification, and finish with your sales contact before running production quantities, particularly if your drawer slide specifies a side thickness or groove position that the box must match.
Cabinet shops running mid-depth drawer programs benefit most here: the pre-cut format cuts setup time on repeat runs, and ordering to a known finished dimension means less measuring and less offcut waste. Kitchen and bath remodelers building out a standard base-cabinet layout will find the 17-1/4 inch length slots directly into common drawer configurations. Shops that already stock Genesis Miterfold sides in other lengths can add this size to cover the mid-depth position without changing their assembly process.
The 18-1/2 inch panel width is the flat dimension before folding. The assembled interior width depends on the material thickness and the miter geometry. Check the Genesis cutting specification for this profile to confirm the finished interior dimension before sizing your drawer front or slide.
Groove specification is not confirmed in the available source data for this SKU. Verify groove position, width, and depth with your sales contact before ordering, especially if your slide manufacturer requires a specific bottom reveal.
The 17-1/4 inch length is sized for mid-depth cabinets and typically pairs with 17 or 18 inch nominal slides, but always verify against your specific slide maker's box-length formula. Undermount slides in particular require the box to be built to a published cutting dimension.
This is the pre-cut side set only. You supply the bottom panel and back to complete the box. The Miterfold format gives you the sides pre-mitered so assembly is straightforward, but the bottom and back are separate shop-supplied components.
When the job calls for a consistent mid-depth drawer box and the schedule doesn't allow for milling from scratch, the Genesis Miterfold 17-1/4 inch side set delivers the dimension you need with the corner work already done.
Sold In: 400 Each
