Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This zinc-finished steel rear mounting bracket completes the back-end support for Pro Value Series PRO 2.0 side-mount drawer slides in face-frame cabinet installations. Without rear support, a slide's back end hangs unsupported inside the face-frame cavity — this bracket, paired with its integrated dowels, anchors it firmly to the cabinet structure so the slide runs true from front to back.
Face-frame cabinets set the cabinet side back from the opening, which means a side-mount slide installed in one lacks support at the rear unless a bracket bridges that gap. Skipping the rear bracket produces a slide that sags, racks under load, or binds mid-travel — common call-backs that cost more to fix than the bracket costs up front. This bracket anchors the back end of the PRO 2.0 slide to the cabinet structure, so the pair runs level and carries its full 100 lb rating across the whole travel range. It suits new face-frame builds and retrofit work equally; since it is non-handed, a single order covers both sides of a drawer opening.
The bracket is stamped steel with a zinc finish. Zinc plating provides solid corrosion resistance for indoor cabinet environments, and the steel construction handles the side and vertical loads a rear bracket sees without flexing. The zinc tone is a neutral metallic that stays unobtrusive inside the cabinet, where the bracket is not visible in normal use. At 3-1/2 in long, 1.87 in wide, and 1.41 in tall, the bracket fits within standard face-frame cavity dimensions without modification.
Cabinet shops running PRO 2.0 slide programs through face-frame production lines order these alongside their slides to keep every drawer install complete in one pass. Contractors retrofitting pullouts into existing face-frame kitchens reach for them when the original install skipped the rear support. Homeowners tackling a cabinet upgrade find the non-handed format straightforward — one part number covers both sides, and no slide replacement is needed when the bracket is the missing piece. In all cases, the bracket is a DSPRO 2.0 system component; it belongs with PRO 2.0 slides, not with other slide series.
It is a DSPRO 2.0 system component, matched to the Pro Value Series PRO 2.0 slide. Rear brackets are series-specific — mounting hole patterns and dowel geometry differ between series — so confirm the match before ordering for a different slide line.
No. In a frameless cabinet, the slide screws directly to the flat cabinet side panel all the way to the back, so no bridging bracket is needed. Rear mounting brackets exist specifically for face-frame construction, where the side panel is recessed behind the frame.
The dowels locate the bracket accurately relative to the slide and cabinet structure during installation. The bracket also mounts with screws — dowels position, screws secure. Check the PRO 2.0 installation guide for screw size and hole pattern before drilling.
Check the quantity shown on this page. Because the bracket is non-handed, one part number covers both cabinet sides — confirm the sold-as unit so you order the right quantity for your drawer count.
A PRO 2.0 slide without its rear bracket is an unfinished system. This zinc steel bracket closes that gap cleanly, keeps the slide level across its full travel, and lets the drawer carry what the slides are rated for — so the job is done right the first time.
Sold In: 168 Each