Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the 12 inch PRO 2.0 series cabinet member, part of the Pro Value full-extension side-mount ball bearing program, sold in a production box of 30 pieces. It is a steel, ball-bearing cabinet member finished in Black, designed for drawer installations where a dark slide blends with dark cabinet interiors or complements black hardware schemes.
Most side-mount ball bearing slides ship in zinc or white, which disappear against light interiors but stand out against dark melamine, painted black box interiors, or cabinet builds where the hardware palette runs black throughout. The PRO 2.0 Black cabinet member closes that gap — the slide stays tucked out of sight when the drawer is open, keeping the focus on the front and hardware rather than the slide beside it. It fits the same 1/2 inch side clearance and 32mm hole pattern as the zinc and white variants, so substituting it into an existing shop layout requires no re-engineering.
The member is cold-rolled steel with a Black powder finish. Steel in this gauge carries the 100 lb per pair rating through years of daily cycling. The finish is consistent across the member length and is applied over the steel before the ball raceways are formed, so the bearing surfaces themselves are not compromised by the coating. This is an indoor slide: the Black finish provides standard corrosion resistance for dry cabinet environments, not a wet or exterior application.
The box of 30 cabinet members suits cabinet shops running drawer packages in black hardware specifications — a run of base cabinets, a bank of office drawers, or a kitchen build where every visible fastener and fitting is black. Each cabinet member pairs with its matching PRO 2.0 drawer member to complete a working slide; order drawer members separately to match this quantity. In face-frame cabinet construction, add the appropriate rear mounting brackets, sold separately, to support the back end of the slide where the cabinet side is set back from the frame.
This is the cabinet member only — the part that screws to the cabinet interior. You need a matching PRO 2.0 drawer member to complete each slide, and two complete slides per drawer. Order drawer members separately to match your cabinet member quantity.
Standard motion means no closing mechanism — no self-close spring, no soft-close damper, and no hold-in detent. On a level cabinet the drawer stays where it is pushed. If you need the drawer to pull itself shut, look at the self-close or soft-close variants in the PRO 2.0 line.
The slides are mechanically compatible within the PRO 2.0 series regardless of finish, but mixing Black cabinet members with zinc drawer members will produce a visible finish mismatch beside the open drawer. For a consistent look, match the finish across both members.
The PRO 2.0 series is sized for standard cabinet drawers. For very wide drawers, check the series specification for the recommended maximum width before building the box.
Yes. In a face-frame cabinet the cabinet side is set back from the face, so the back end of the slide needs a rear mounting bracket for support. The brackets are sold separately and are series-specific — use PRO 2.0 compatible brackets, not generic hardware.
When the cabinet interior or hardware spec calls for black, this 12 inch PRO 2.0 cabinet member keeps the slide from competing with the finish work — full extension, 100 lb capacity, and a non-handed design that moves through a production run without sorting.
Sold In: 60 Each
Quantity | Unit Price | Catalog | ||||
|---|---|---|---|---|---|---|
Sold in: 1000 Each |  WW46000 Mfr# 3670000235961 1000 | Würth #8 x 7/16" Truss Head Hinge and Drawer Slide Installation Screw Phillips Drive - Sharp Point Coarse Thread Zinc, 3670000235961 1000 - 1000/Box |
