Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Belwith concealed hinge brings soft-close damping and a half overlay geometry to frameless cabinets, finished in Polished Nickel for installations where the hardware stays visible in the interior.
Half overlay is the configuration for double-door cabinets where two doors meet at a shared center partition, each covering roughly half of that panel. The half crank arm sets that position precisely, so both doors close to an even reveal without the arms colliding. The 35mm cup bores into the back of the door at a 45mm boring pattern, and the hinge screws to a base plate on the cabinet side, ordered separately. Screw-on mounting fastens with standard wood screws into the cabinet panel, making it a straightforward fit on frameless boxes that are not set up for system-hole mounting. A matching Belwith base plate is required to complete the installation.
The hinge body is steel, finished in Polished Nickel. That finish reads bright and reflective, which coordinates naturally with chrome pulls, polished knobs, and other reflective hardware. On open-frame or glass-front cabinets where the interior hardware is occasionally visible, the finish makes a difference. The soft-close mechanism is integrated into the hinge, so the damped close is consistent across every door without adding a separate adapter.
Cabinet shops and contractors fitting out double-door frameless cabinets will find this hinge straightforward to specify: half overlay geometry, soft-close built in, and a finish that holds up in a kitchen or bath environment. It fits standard doors in the 16 to 22mm range. The screw-on plate mount means no pre-drilled system holes are needed, which extends the compatibility to shop-built boxes and custom frameless work. Homeowners replacing existing half overlay hinges on a frameless cabinet will also find this a direct fit provided the 35mm cup and 45mm boring pattern match the existing holes.
The base plate mounts to the cabinet side and is sold separately. Use a matching Belwith plate sized for your frameless cabinet and the half overlay position.
Each door covers roughly half the shared center partition, so the two doors meet at the partition with an even reveal between them. Full overlay arms would cause the two arms to collide at the partition, so half overlay is the correct geometry here.
Yes. Screw-on mounting uses wood screws directly into the cabinet panel, so it does not depend on 5mm system holes. It is compatible with shop-built and custom frameless boxes.
If your existing doors were bored for a standard 35mm cup at a 45mm boring pattern, this hinge is a direct replacement fit. Measure the existing hole and spacing before ordering.
Specify this hinge when a double-door frameless cabinet calls for half overlay, soft-close damping, and a Polished Nickel finish that coordinates with the rest of the hardware on the job.