Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The GS2070 Metal Rear Mounting Bracket from Knape and Vogt's GSlide series provides the rear support that face-frame cabinet installations demand. When the cabinet side is set back from the frame, the back end of a drawer slide needs a solid bearing point — this screw-on metal bracket delivers that support in a zinc-finished steel build sized for the GSlide program.
Face-frame cabinets set the cabinet side walls back from the front frame, which means a drawer slide mounted at the front has nothing at the back to attach to. Without a rear mounting bracket, the slide hangs unsupported — and under a loaded drawer, that unsupported end deflects, binds, or fails outright. The GS2070 bridges that gap, giving the back of the slide a firm screw point at the cabinet rear. This is the most commonly overlooked part in a face-frame slide order, and ordering it in the same pass as the slides avoids a second shipment before the job can finish.
The bracket is metal with a zinc electroplate. Zinc plating on steel hardware is a standard indoor corrosion protection that handles the humidity cycles inside a kitchen or bathroom cabinet without surface degradation. The finish reads as a clean, neutral silver tone inside the cabinet — close enough to typical zinc-plated slide hardware that nothing looks mismatched. This is an interior application component; it is not rated for outdoor or wet-area use.
Cabinet shops building face-frame boxes with GSlide slides are the primary audience. Contractors retrofitting slides into existing face-frame cabinetry — where the original rear support hardware has gone missing or was never included — will also reach for this bracket. It is not a universal fit: the GS2070 is a GSlide series component, and rear mounting brackets are series-specific. Pair it with GSlide slides; do not substitute it into other slide programs and expect a clean result.
Yes, in most cases. When a drawer slide is mounted at the front of a face-frame cabinet and the cabinet side is recessed behind the frame, the rear end of the slide has no direct attachment surface. A rear mounting bracket supplies that attachment point. Frameless cabinets do not have this gap and typically do not need a separate rear bracket.
A complete drawer installation uses one bracket per slide, which means two brackets per drawer — one on each side at the rear. Check the pack quantity shown on this page to confirm how many pieces are included in your order.
This bracket is a GSlide series component from Knape and Vogt. Rear mounting brackets are matched to their slide program — hole patterns, dimensions, and mounting geometry vary by series. Use GSlide brackets with GSlide slides; do not mix with other programs.
The bracket uses screw-on mounting, driven into the cabinet back or rear stretcher. Screw size and count depend on the bracket's hole pattern; refer to the GSlide installation guide for the recommended fastener spec.
Add the GS2070 to the same order as your GSlide slides and the rear of every drawer in a face-frame cabinet has the support it needs — no callbacks, no second shipment, no half-finished installs waiting on a forgotten bracket.
Sold In: 1 Each
