Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is a Blum LEGRABOX Thinfront front fixing bracket in Zinc, sized for C-height drawer systems and designed to attach a thin drawer front to the steel LEGRABOX side profiles with full adjustment capability.
When a project calls for a thin or frameless drawer front — common in contemporary kitchens and minimalist cabinetry — the Thinfront bracket gives that front a secure mechanical connection to the LEGRABOX side profile without visible hardware crowding the face. The bracket mounts to the C-height side profile and provides the adjustment points needed to align the front after hanging. Because the bracket is non-handed, the same part goes on both sides of a drawer, which simplifies ordering and stocking. This bracket is matched to the LEGRABOX soft-close runner system; it works with the integrated damping that brings the drawer to a quiet close rather than a hard stop.
The Zinc finish on this bracket is not a coating name — it reflects the raw zinc-alloy or zinc-plated steel presentation that matches LEGRABOX side profiles finished in the same Zinc colorway. Inside a kitchen or bath cabinet, the bracket is partially visible between the front and the side profile, so finish consistency matters. Steel construction keeps the bracket rigid under the 155 lb system load rating, which means it can support a fully loaded drawer without the bracket flexing and throwing off front alignment. For a build where the LEGRABOX sides and runners are already in Zinc, this bracket completes the interior without introducing a finish mismatch.
Cabinet shops running LEGRABOX in Zinc on contemporary kitchen projects will reach for this bracket whenever the specified drawer front is on the thinner side — thin-profile slab fronts in lacquer, veneer, or high-gloss laminate, for example. Designers specifying handle-less kitchens with push-to-open or bar-pull fronts often call out the Thinfront bracket because it keeps the front gap clean. Kitchen and bath installers who need to align multiple drawer fronts across a tall bank of drawers will find the built-in adjustment useful for squaring the layout without removing the fronts. The non-handed design also means a single line item covers all drawer positions, left and right, in a project.
No. The Thinfront bracket is a distinct part shaped for thinner front profiles. Standard LEGRABOX front fixings are sized differently and are not interchangeable with Thinfront brackets.
You need two brackets per drawer, one per side. Because the bracket is non-handed, the same part number covers both sides — order two of this SKU per drawer opening.
The bracket is dimensionally matched to C-height runners regardless of finish, but the Zinc colorway is selected to pair with Zinc side profiles. If your runners are a different finish, choose the bracket in the matching finish for a consistent interior.
No. This bracket is part of the LEGRABOX system and is not compatible with TANDEMBOX, METABOX, or other Blum platforms. Front fixings are system-specific.
A front that drifts out of alignment over time is almost always a bracket fit problem, not a runner problem. Using the system-matched Thinfront bracket in the correct finish and height keeps the front where you set it, so the gaps stay even and the soft-close runner does the job it was designed to do.
Sold In: 1 Each
