
Order by 24/7 by web, contact our sales reps or call by phone.

What you need, when you need it, all in one place.

Most orders ship same day.

Advice and support from knowledgeable professionals.
This Rev-A-Shelf 548 Series undersink pullout organizer brings order to the cabinet below the sink, rolling out on ball-bearing slides to give full access to cleaning supplies, sponges, and under-sink storage across two open wire tiers.
The sink base cabinet is one of the least organized spaces in most kitchens and bathrooms. Plumbing runs through the middle, the interior is deep, and anything stored at the back tends to stay there. This two-tier pullout solves that by rolling the whole storage stack forward when you need it. The upper and lower wire tiers work around the plumbing footprint and keep bottles, sprays, and scrub brushes separated so nothing disappears behind a drain pipe. Because the wire is open, a splash or drip passes through to the cabinet floor rather than sitting on a shelf surface.
The organizer is built from steel wire in a chrome finish, which gives it a clean, bright look that holds up in a damp undersink environment. The open wire construction means the frame stays light even when the tiers are fully stocked. The ball-bearing slides are the detail that makes the daily-use case work: a loaded unit comes out and goes back with consistent, even resistance rather than dragging or catching. At 9-3/4 inches wide and 16 inches long, the unit fits the depth of a standard sink base and leaves room on either side for the plumbing stack.
This organizer is the right choice for a kitchen sink base where cleaning supplies are the primary storage category, or a bathroom vanity base where personal-care products, spare soap, and cleaning tools tend to pile up. The 10-inch minimum cabinet opening means it works in narrower sink bases that would exclude a wider unit. Cabinet shops and installers fitting out new kitchens will find it a straightforward drop-in that addresses one of the most-complained-about storage problems in residential cabinetry. Homeowners doing a focused organization upgrade can install it without a door mount, which keeps the job simple.
The open two-tier wire frame is designed to work around the drain and supply lines common in sink base cabinets. Exact plumbing clearance depends on your specific installation, so check the 9-3/4 inch width and 16-inch depth against your cabinet interior before ordering.
No. This unit does not include door-mount hardware and installs as a pullout fixed to the cabinet interior, not to the door.
The minimum cabinet opening is 10 inches wide. Measure the clear interior opening of your sink base before ordering.
Yes. The compact footprint and two-tier layout work well under a bathroom vanity wherever the cabinet opening is at least 10 inches wide.
Choose this chrome wire pullout to turn a cluttered sink base into a two-tier organized system that rolls out fully on every use.
Sold In: 1 Each