Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune CN-A362 is a tab pull from the CN series, sized for cabinet doors and drawer fronts where a 3-5/8 inch (92 mm) hole spacing already exists or is being laid out fresh. Its low-profile tab form and Satin Nickel finish suit contemporary cabinetry that calls for hardware that functions cleanly without drawing attention to itself.
The 3-5/8 inch center-to-center spacing makes this pull a natural fit for cabinet doors and narrower drawer fronts. On a door, the compact overall length keeps the hardware proportional to the front without extending toward the edge or the hinge. On a shallow drawer, the tab form reads as a deliberate design choice rather than a compromise, and the fingertip grip suits the lighter pull weight those fronts require. This is also a practical choice when replacing existing hardware drilled to a 92 mm pattern, since the hole spacing matches without any additional drilling.
The CN-A362 is machined from brass and finished in Satin Nickel, a matte-brushed silver tone that sits between the warmth of chrome and the flatness of a matte white or black. The brushed texture keeps fingermarks from reading as clearly as they would on a polished surface, which matters on frequently used doors. Satin Nickel coordinates readily with stainless appliances, brushed fixtures, and other silver-tone hardware already in the room, making it one of the more versatile finish choices in a contemporary kitchen or bath.
This pull suits designers and cabinet shops specifying hardware for contemporary kitchens, bathrooms, and built-ins where the hole pattern runs at 92 mm and the finish program is silver tone. It also fits homeowners replacing worn or mismatched door hardware without redrilling. The CN series carries companion pieces in the same design language, so it is straightforward to run this pull on doors while using a wider CN series pull on drawer banks, keeping the hardware program cohesive across the whole installation.
92 mm (3-5/8 inch) is a common spacing on cabinet doors and narrower drawers. It is not as widely seen as 96 mm (3-3/4 inch), so measure between the centers of your existing holes before ordering if you are replacing hardware.
A tab pull is a low-profile pull gripped with the fingertips rather than the full hand. The tab sits close to the door face and the grip comes from reaching the fingers behind the 1-3/8 inch projection. It is a natural motion on a door and a light drawer.
Satin Nickel is a brushed silver-tone finish that coordinates well with stainless and brushed nickel fixtures in general, but finish appearance varies by manufacturer. The CN-A362's Satin Nickel finish should be compared directly to your existing hardware before specifying across a large project.
Yes. The 92 mm spacing and compact overall length make it work on both doors and narrower drawers. For wider drawer fronts, a longer CN series pull with a greater center-to-center measurement may be better proportioned.
When the hole pattern is 92 mm and the finish program calls for Satin Nickel, the CN-A362 delivers a solid brass tab pull that installs cleanly and coordinates across the CN series without requiring a second finish or a different design language.