Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune DSI-110-160 is a contemporary bar pull from the DSI-110 series, mounting on 6-5/16 inch (160 mm) centers and finished in Satin Stainless Steel.
A 6-5/16 inch (160 mm) center-to-center is the step between the common 5-1/16 inch spacing used on mid-width drawers and the 7-9/16 inch spacing used on the widest base drawers and appliance-scale fronts. It lands on wide base drawers in the 24 to 30 inch range, on taller pantry doors where a longer grip reads proportionally, and on islands or furniture-style pieces where the hardware needs presence without dominating the panel. It is also the spacing to reach for when replacing existing 160 mm hardware without redrilling.
The Satin Stainless Steel finish is a brushed surface, not a polished one. The brushed texture diffuses light rather than reflecting it as a single bright line, so the pull reads consistently across kitchens with different lighting setups. In practical terms, a satin surface shows fewer prints than a high-polish finish and wipes clean without leaving streaks. Stainless is also one of the metals that coordinates naturally with the finish on most residential and commercial-grade appliances, which is a genuine convenience in a kitchen where the refrigerator, dishwasher, and range are already stainless.
This pull is a natural fit for cabinet shops specifying hardware across a full kitchen where drawer widths vary. The DSI-110 series runs in multiple center-to-center sizes, so a shop can hold one series across every run — narrow drawers, wide drawers, and pantry doors — and deliver a consistent look without mixing brands or profiles. For designers working on contemporary or transitional kitchens, the squared bar and satin finish integrate cleanly with flat-slab and shaker fronts in light or dark finishes. Contractors doing a spec build or a renovation where stainless appliances are already in place will find this pull simplifies the coordination decision.
Center-to-center is the drilling dimension: 6-5/16 inches (160 mm) between the two hole centers. Overall length is the end-to-end size of the pull at 7-1/2 inches (191 mm), which is larger. Drill to the center-to-center figure, not the overall length.
Squared, at 1-9/16 inches across, so the face of the grip sits flat and presents a uniform line along the drawer or door front.
Satin Stainless Steel is in the same finish family as most residential stainless appliances, and the visual coordination is generally close. Exact sheen levels vary by appliance manufacturer, so a physical sample comparison is the reliable way to confirm before specifying a full kitchen.
Yes. The DSI-110 series is available in multiple center-to-center sizes, so you can run the same profile and finish across different drawer and door widths in one cabinetry program.
When the drawer bank calls for a 160 mm spacing and the kitchen is running stainless, this pull covers both without compromise.