Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Sugatsune DSI-120 pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
The 6-5/16 inch center-to-center falls in a range that handles a lot of real cabinetry without requiring a long pull or a short one. On a mid-width base drawer it gives the hand a natural, centered grip. On an upper cabinet door it reads as deliberate hardware rather than as a small accent. It is also the spacing where pull and door proportions tend to align well without a designer needing to do much math. For a kitchen where the drawer bank and the upper doors share a single pull size, 160 mm is one of the few spacings that makes that practical.
The DSI-120 is built around a clean bar section, 1-3/16 inches wide, that sits on two posts and presents a flat face to the room. Satin Stainless Steel is a brushed surface, so it does not pick up the point-source reflections that a polished finish does. Under kitchen lighting it reads as a cool, even silver tone rather than a bright one. The satin texture also makes daily fingerprints and smudges less visible than a mirror surface, which matters on hardware that is touched dozens of times a day. The bar geometry and the matte sheen together give the pull a workmanlike quality that suits contemporary cabinetry without competing with it.
This pull fits naturally into a contemporary or transitional kitchen, bathroom vanity, or built-in unit where the hardware finish is stainless or brushed silver and the door program is flat or minimally profiled. The 1-9/16 inch projection is on the deeper side for a bar pull, which makes it especially comfortable to grip on a frequently used base drawer. Because this is a DSI-120 series piece, it coordinates directly with the other spacings in the collection, so a shop or designer running multiple center-to-center dimensions across one project can source them from a single consistent series rather than mixing product lines.
Center-to-center, 6-5/16 inches (160 mm), is the distance between your two mounting holes and the only dimension that needs to match your existing drilling. Overall length, 6-1/2 inches (165 mm), is the full end-to-end size of the pull and is slightly larger.
Satin Stainless Steel is a brushed, low-sheen surface. It shares the same general look as what many people call brushed stainless but is Sugatsune's own finish name for this product.
Yes. The 160 mm spacing works on both, and using one pull across doors and drawers is a common approach in contemporary kitchens where a single hardware size is part of the design intention.
The DSI-120 collection includes pulls at multiple center-to-center spacings, so you can match the design language across different door and drawer widths in the same project.
Choose this pull when 160 mm centers cover most of your doors and drawers and you want a satin stainless bar that reads the same across the whole run.