Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune DSI-3010-40 is a 40mm (1-9/16 inch) diameter round pull from the DSI-3010 series, designed for sliding doors and panel applications where a low-profile grip in stainless steel is the right fit.
Sliding doors have a clearance problem that swinging doors do not: the pull must not extend so far from the face that it catches on the frame, the adjacent panel, or the pocket opening as the door travels. At 1/4 inch (6 mm) projection, the DSI-3010-40 stays well inside that margin. It is a practical choice for barn door hardware installations, pocket doors, and sliding panel systems in kitchens, built-ins, libraries, and room dividers where the door travels past fixed elements. The 40mm diameter gives the hand enough surface to grip and pull without requiring any projection to speak of.
This pull is made from stainless steel and finished in Satin Stainless Steel. The satin surface is brushed rather than polished, which keeps the sheen even under directional light and reduces the visibility of handling marks over time. Stainless steel as the base material brings dimensional stability and resistance to the humidity fluctuations common in kitchens and bathrooms, which is exactly where sliding panel systems are most often installed. The finish reads as a cool silver tone that coordinates with contemporary fixtures without competing with them.
This pull is well suited to designers and cabinet shops specifying hardware for sliding door systems where clearance is tight, the finish program is stainless or brushed silver, and the hardware needs to hold up to daily use without drawing attention to itself. It also works for contractors sourcing a single consistent pull for a run of sliding panels across a larger project. The round form is non-directional, which simplifies installation across doors of varying orientations.
A sliding door travels along a track past the frame, the pocket opening, or the adjacent panel. A pull that stands too far off the face will snag on those elements as the door moves. At 1/4 inch (6 mm), this pull stays close enough to the face to clear most standard sliding door installations.
No. Because the pull is round, there is no top or bottom to orient. It installs the same way regardless of which direction the door slides.
The DSI-3010 series is available in additional diameter sizes. This SKU is the 40mm version.
Satin Stainless Steel is Sugatsune's finish name for this pull. Finish appearance varies between manufacturers, so coordinate within the DSI series for the closest match rather than assuming it will match another brand's stainless finish exactly.
When the job calls for a pull that grips cleanly, clears the frame as the door travels, and holds a satin stainless finish across years of daily use, the DSI-3010-40 is the specification that fills all three requirements without compromise.