DSI-3020 sliding door pull 300mm long SS describes a surface-mount handle set from the DSI 3020 Series designed for sliding door applications. This handle set uses 304 stainless steel, so it provides a durable metal gripping surface where doors are used regularly in a woodworking or cabinet setting. The satin finish on the stainless steel creates a low-glare appearance that coordinates well with other satin decorative hardware and moldings in the same project. The set is sold as a set with 2 metal handles and 1 edge-mounted recessed pull, so the installer can outfit both faces of a door and the edge in one matching configuration. The recessed pull is specified for use with wood doors, which gives sliding wood doors a clean edge grip that sits into the door rather than on the face.
This surface-mount handle DSI 3020 Series arrangement means both handles are intended to mount on the door face, which creates a straightforward installation pattern on sliding doors. Because the pull is 300 mm long, installers can position it vertically or horizontally to match the door design while still giving users a long gripping span. The edge-mounted recessed pull is specifically described as for use with wood doors, so it fits into a machined pocket in the door edge to create a flush grip point. Using 304 stainless steel for these components supports firm fastening at the mounting points and stable performance under typical sliding operation in wood door applications.
This Sugatsune DSI-3020 Series handle and pull arrangement is aimed at sliding door projects where a surface-mount handle and edge-mounted recessed pull are both needed. The 300 mm, 11-13/16 inch pull length suits full-height wood sliding doors or larger cabinet doors that benefit from a longer handhold. Because the recessed pull is designated for use with wood doors, it suits wood-based sliding doors commonly used in cabinetry or interior woodworking work. The satin stainless steel finish allows these handles and the recessed pull to coordinate with other satin stainless handles and pulls from Sugatsune America or similar decorative hardware and moldings in the same installation.
The sold as a set configuration, with 2 metal handles and 1 edge-mounted recessed pull, is organized so both sides of a sliding door can use identical surface-mount handles while the edge receives a recessed pull. That arrangement keeps the gripping experience consistent from either approach side of the door while giving a dedicated edge grip where the door is recessed. The 304 stainless steel material used across the surface-mount handles and recessed pull means each contact point shares the same metal construction and surface characteristics. Because the pull length is defined as 300 mm, installers can repeat that dimension across multiple doors to maintain visual alignment and predictable hand placement on every sliding wood door in the run.
The DSI-3020-300 is a surface-mount handle from the DSI 3020 Series, so it attaches to the door face and serves as a pull for sliding door operation.
The Sugatsune DSI-3020-300 set uses 304 stainless steel, giving the handles and recessed pull a solid metal construction for frequent use on sliding doors.
The Sugatsune DSI-3020 sliding door pull has a satin stainless steel finish, which supports a low-glare look that coordinates with other satin hardware.
The DSI-3020-300 pull handle is 300 mm, or about 11-13/16 inches long, giving users a generous gripping surface along the sliding door.
The edge-mounted recessed pull in this set is specified for use with wood doors, so it is routed into the door edge for a flush gripping point.
This handle set is produced by Sugatsune America under manufacturer part DSI-3020-300, which identifies it within the DSI 3020 Series.
The Sugatsune DSI-3020-300 surface-mount handle and recessed pull set combines 304 stainless steel construction, a 300 mm long pull, and a satin finish tailored to sliding wood doors. Using this defined set supports consistent grip points and matching hardware across sliding door runs.