Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune MKZ pull is a compact rectangular cabinet pull designed for doors and drawer fronts where the mounting centers are drilled at 7/16 inch (11 mm) apart. At that spacing it fills a role no standard-pitch bar pull can, making it the right choice for small overlay doors, thin drawer fronts, and specialty cabinet applications that demand precise fitment.
An 11 mm center-to-center is not a standard cabinetry dimension, and that is precisely why this pull exists. It appears on compact overlay doors in appliance garages, narrow spice pull-outs, small jewelry or hobby cabinet drawers, and specialty furniture pieces where the front is too narrow to accommodate a conventional pull pitch. It is also the hardware of choice when existing holes are pre-drilled at this spacing and replacement needs to match exactly. Reaching for a longer pull to cover the gap introduces holes that do not align, so fitting the hardware to the actual spacing is the only clean solution.
The pull is cast in zinc and finished in Polished Brass. The polished surface delivers a high-sheen gold tone that reflects cleanly under cabinet lighting, giving even a small piece of hardware a noticeable presence. Polished Brass reads warm and formal against both light and dark fronts, and it pairs naturally with other gold tone fixtures in traditional and transitional interiors. Because it is a polished finish, it will show fingerprints more readily than a brushed or matte surface, and it wipes clean with the same ease.
Cabinet shops building out specialty interiors, furniture makers working on smaller-scale pieces, and contractors sourcing replacement hardware for existing pre-drilled fronts are the most common buyers here. The 11 mm pitch is specific enough that there is rarely a substitute: if the holes are already there, this pull is the answer. Designers specifying gold tone hardware programs will find that the MKZ series coordinates across its available finishes, making it possible to carry the same profile through multiple cabinet zones at different scales.
Most cabinet pulls are drilled to 96 mm, 128 mm, or similar standard pitches. The 11 mm spacing is used for compact specialty applications where the front is too narrow or too short to carry a standard pull, or where a manufacturer has pre-drilled to a closer pitch for a specific door or drawer type.
It works on either. Because of its compact overall length and close hole pitch, it is most often used on small doors and narrow drawer fronts rather than on full-width cabinetry.
Finish names are manufacturer-specific. Polished Brass from the MKZ series should be matched within the Sugatsune line for consistent results. Two manufacturers' brass finishes can vary noticeably in tone and sheen even when they share a name.
1 inch (25 mm) end to end. The 7/16 inch (11 mm) figure is the center-to-center mounting dimension, which is always smaller than overall length.
When the holes are drilled at 11 mm and the finish program calls for Polished Brass, this pull resolves both constraints in one piece without compromise.