Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune RD-45/CR is a tab pull from the RD Series, designed for cabinet doors and drawer fronts where a small, precise grip fits the scale of the front better than a full bar pull would.
A 32 mm center-to-center spacing is one of the tightest standard hole patterns in cabinet hardware, and this pull is built around it. That makes it a natural choice for narrow spice drawers, small utility doors, appliance garage fronts, and any cabinet face where a longer pull would run edge to edge or look out of proportion. The tab form suits these applications because it presents a clean, minimal grip without the visual span of a bar pull. It also works well as the door knob substitute in a hardware program where the designer wants a unified pull look across both doors and drawers rather than mixing knob and pull forms.
The pull is cast in zinc and finished in Polished Chrome. A polished surface on a tab this size reads as a bright point of light on the front rather than a continuous highlight, which is a different effect than the same finish on a longer bar. Chrome coordinates naturally with stainless appliances and chrome plumbing fixtures, so this pull is a straightforward fit in a kitchen or bath already running that metal. The RD Series carries a contemporary design language, so the pull belongs on flat-fronted cabinetry where the hardware is meant to be minimal and precise rather than decorative.
This pull suits the designer or cabinet shop specifying a uniform hardware program across a mixed run of drawer widths, where the narrowest fronts need their own correctly scaled grip. It also suits a homeowner replacing hardware on a bank of small drawers or a row of upper cabinet doors where the existing hole pattern is already drilled to 32 mm centers. At this scale, Sugatsune's RD Series is a consistent choice for contemporary kitchens, home offices with built-in cabinetry, and bath vanities where the hardware should read tidy rather than prominent.
Center-to-center, 1-1/4 inches (32 mm), is the distance between the two mounting holes and the number to match when replacing existing hardware. Overall length, 1-3/4 inches (44 mm), is the full end-to-end size of the pull including the posts.
The projection is 3/4 inch (19 mm), measured from the face of the front to the back of the grip.
A polished surface shows marks more readily than a brushed finish and wipes clean just as easily. On a tab this size, the area to wipe is minimal.
Yes. The tab form mounts through two holes and works on doors and drawers alike, provided the front has the 32 mm hole pattern or is being drilled new.
When the cabinet front is narrow and the hole pattern is already set at 32 mm, this pull delivers a clean, chrome grip without asking the front to accommodate more hardware than it has room for.