Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Sugatsune PXB coat and hat hook is a staggered two-prong wall hook combining a rubber body with a steel core, finished in Black and sized at 2-1/2 inches in length.
At 2-1/2 inches of projection, this hook extends far enough to carry a folded coat or a brimmed hat without either pressing flat against the wall. That reach is the practical middle ground in the PXB line: enough clearance for everyday outerwear without pushing the prong into a narrow corridor or doorway. In an entryway with limited depth, the difference between a 1-1/2 inch prong and a 2-1/2 inch one is whether a heavy jacket stays put or slides off the tip. The staggered arrangement separates the hat above from the coat below, so both hang without sitting on top of each other. The 3 inch overall height is compact enough that two or three of these can run in a short span without crowding.
The hook is built from rubber over a steel core. Rubber handles contact differently than cast zinc or solid metal: it gives slightly under pressure, which means hung items are less likely to be marred by the hook itself, and the surface resists the kind of chipping and peeling that plated finishes can show at high-contact points. The Black finish runs through the whole piece rather than sitting on a different-colored substrate, so a small ding does not read as a color contrast. This is a purposeful, low-maintenance material choice rather than a decorative one, and it suits workhorses more than showpieces.
The PXB GR05 suits a busy entryway, a mudroom, a back hallway, or a utility closet where hooks take daily handling and a softer touch against hung items is welcome. The Black finish coordinates readily with dark-toned cabinet hardware, matte black fixtures, or industrial-adjacent interior schemes. Designers specifying hooks for a mudroom bench or a locker-style entry will find the slim 9/16 inch width keeps the hook from dominating the wall even when multiple units run side by side. Cabinet shops and contractors fitting out entry storage can use these on wood rails or directly on a painted wall panel without worrying about the hook's surface scratching the substrate on installation.
The material is listed as rubber and steel, with the rubber forming the body of the hook rather than a tip coating only.
This is a coat and hat hook, so the prongs are staggered: one arm sits higher for a hat and one lower for a coat.
The PXB series is Sugatsune's collection for this hook family, so companion pieces in the same series share the design language and Black finish.
Both the projection and the overall length are 2-1/2 inches (64 mm) on this hook, as listed in the product attributes.
Choose this hook when the priority is a resilient, non-marring prong with a genuine reach, in a finish that holds up to a heavy traffic spot without showing wear.