Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #6 x 1/2" hinge and drawer slide installation screw is purpose-built for attaching European cup hinges, drawer slides, and cabinet hardware to cabinet panels where short penetration depth is required. The flat head, coarse thread, Type 17 Auger point, and #2 square drive work together to deliver fast, consistent seating across high-volume cabinet production and installation work.
At 1/2", this screw is matched to the mounting plates on European cup hinges and standard drawer slide brackets, where the combined thickness of the hardware plate and the required thread engagement leaves little room for a longer fastener. Thin cabinet panels, melamine-faced carcass sides, and face-frame members with limited depth behind the mounting surface are exactly the conditions this length handles cleanly. Driving a longer screw in these situations risks breaking through the back face of the panel or reducing the integrity of the substrate around the hole. The 1/2" length threads fully into the panel without those risks.
The Nickel finish gives the screw head a polished, neutral appearance that coordinates well inside white, gray, or natural-finish cabinet interiors where screw heads stay exposed after hardware installation. The #6 gauge is the standard match for the pre-bored mounting holes in most European hinge plates and drawer slide brackets, so heads seat correctly against the hardware without rocking or leaving a gap. The square drive recess is intended for use with a correctly sized #2 square bit. When the bit fits precisely, the geometry supports positive engagement during driving, which matters when working inside a cabinet box where repositioning is awkward.
Cabinet shops running high-volume production keep this screw staged at every assembly station where hinge and slide hardware gets mounted. The 25,000-piece box supports that kind of continuous throughput without frequent restocking interruptions. Installers working on-site find the short length and controlled drive equally useful when fitting hinges and slides into finished cabinets in place, where depth clearance behind panels is not always known in advance. The Type 17 Auger point reduces the starting resistance that slows any repetitive mounting task, which adds up across dozens of doors and drawers in a single kitchen installation.
Yes. The #6 gauge is the standard diameter for the pre-bored holes in most European hinge mounting plates, and the flat head seats flush against the bracket face without standing proud.
Most hinge plate and drawer slide bracket holes are positioned so that 1/2" provides full thread engagement in the panel without risk of breaking through a thin carcass side or melamine-faced substrate. Longer screws in those locations can damage the panel back face.
The Type 17 Auger point has an extended fluted tip that clears material as the screw enters. This reduces the torque needed to drive the screw and lowers the risk of splitting in denser panel materials like MDF and particleboard.
Yes. The coarse thread provides strong pull-out resistance in particleboard, MDF, and plywood, which are the panel materials used in most production cabinet carcasses.
It depends on throughput. A shop assembling dozens of cabinets per week will cycle through the quantity steadily. For lower-volume work, smaller pack sizes in this family may be a better fit.
When hinge and drawer slide hardware goes on cleanly and stays put, the rest of the install follows. This 1/2" Nickel installation screw gives production shops and on-site installers a fastener sized precisely for shallow-panel hardware mounting, with the point, thread, and drive to handle it efficiently at volume.
Sold In: 25000 Each