Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Salice F70 Tilt Adjustment Lever Set gives installers a simple, tool-assisted way to correct drawer front tilt on F70 series undermount slides. Where a slightly skewed front would otherwise require repositioning the whole drawer, these plastic levers provide a dedicated 3mm tilt correction built into the slide system itself.
Drawer front tilt shows up when one side of the front sits slightly higher or lower than the other, leaving a gap that tapers across the reveal. On the F70 undermount system, tilt adjustment is handled at the slide level through the locking device and adjustment levers rather than by loosening and repositioning the front. The 3mm lever set addresses tilt that falls within that correction range, restoring an even reveal without disturbing the front's horizontal or depth settings.
The levers are molded from plastic, which keeps them light and free from corrosion inside the drawer cavity. Because F70 system components are engineered to tolerance, the adjustment geometry depends on using the correct lever set for the slide series. A lever from a different Salice series or a third-party part will not deliver the same correction range or seat correctly in the F70 locking device.
Cabinet installers and shop crews running Salice F70 undermount slides will reach for this lever set during final alignment, particularly on drawers with faces that need tilt correction after the box is hung. It is also a practical part to stock for service calls — a single misaligned drawer front is a quick fix when the right lever is already on the truck. Designers and homeowners specifying F70 hardware should confirm the lever set is on the order when F70 slides are part of the project, since it is a separate component from the slide itself.
No. The F70 tilt adjustment lever is engineered for the F70 undermount platform. Other Salice series use their own adjustment components, and parts are not interchangeable across series.
The 3mm figure is the correction range the lever provides at the slide level. If your drawer front tilt exceeds that range, the front position itself may need to be reset before using the lever for fine-tuning.
The product is listed as a set. Confirm the quantity covers your application before ordering multiple drawers, since each drawer requires levers on both sides for consistent correction.
Tilt adjustment on Salice F70 locking devices is typically made with a screwdriver or adjustment tool at the locking device; the lever itself seats into the system mechanically. Refer to the F70 installation guide for the adjustment procedure.
A level drawer front is the mark of a finished installation, and the F70 tilt adjustment lever set is the part that gets it there without starting over.
Sold In: 1 Set
