Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This metal rear mount bracket set gives Quadro V6 undermount slides the rear support they need in face-frame cabinet installations, with screw-on mounting and built-in 2D side adjustment to true up the drawer front after installation.
Quadro V6 undermount slides mount directly to the cabinet side in a frameless box, but in a face-frame cabinet the side panel is set back from the opening. Without a rear bracket, the back end of the slide has nothing to register against, and the drawer will rack or sit unevenly. This bracket bridges that gap, giving the rear of the slide a solid, adjustable anchor point. It suits any face-frame project where Quadro V6 slides are already specified — kitchen cabinets, bath vanities, built-in furniture, and casework with traditional framed construction.
The bracket is metal throughout, which keeps it from flexing or creeping under the side loads a drawer puts on its rear support. Screw-on attachment means installation fits naturally into a hand-tool or router-table workflow — no line-boring setup needed. The 2D adjustment range of +/- 2 mm is dialed in at the rear bracket, giving installers a clean way to correct small alignment variances after the drawer is hung and the front is set.
This bracket is for shops and installers who are already running Hettich Quadro V6 undermount slides and need the correct rear support for face-frame work. It is not compatible with other Quadro versions or with undermount slides from other brands — rear brackets are series-specific hardware, and mixing them produces fit problems that cannot be adjusted away. If your project uses frameless construction where the slide side-mounts flush to the cabinet panel, you do not need this bracket.
Yes, in most face-frame installations the rear of the slide requires this bracket to anchor and support it properly. Check the Quadro V6 installation guide to confirm the requirement for your specific cabinet depth and construction.
2D means the bracket adjusts in two directions. The +/- 2 mm side adjustment lets you shift the rear of the slide left or right to align the drawer front evenly in the opening after it is hung.
This bracket is specified for the Quadro V6 series. Confirm compatibility with your exact Quadro V6 variant against the Hettich installation documentation before ordering, as version-specific differences in the runner profile can affect bracket fit.
No. Rear brackets are engineered to the geometry of a specific slide series. This bracket fits Quadro V6 and should not be used with Quadro V6 predecessors, other Quadro versions, or undermount slides from other manufacturers.
A Quadro V6 drawer that is well-supported front and rear runs true, adjusts cleanly, and stays aligned through years of use. This bracket is the part that makes face-frame work with Quadro V6 slides viable — small, purpose-made, and exactly what a complete installation requires.
Sold In: 1 Each