Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune Olympia 360-C26-0T is a self-close concealed hinge built for inset doors on both face-frame and frameless cabinets, finished in nickel and screw-mounted directly to the cabinet.
An inset door sits inside the cabinet opening rather than over it. That flush look is the whole point, and it depends entirely on the hinge carrying the door in the right position. The Olympia's full crank arm holds the inset geometry so the door sits square within the opening with an even gap on every edge. The 35mm cup bores into the door back at a 45mm bore pattern, and the hinge screws to the cabinet, with a matching base plate ordered separately. The self-close spring means the door pulls shut on its own once released, so there is no need for a separate catch to keep it closed.
The hinge body is steel with a nickel finish. Nickel reads as a warm, versatile mid-tone that works well alongside brushed nickel pulls, knobs, and other visible hardware, keeping the metal palette consistent across the cabinet face. The screw-on mount anchors the hinge firmly to the cabinet rather than relying on a tool-free clip, which suits applications where a mechanically locked connection is preferred. The hinge is sized for doors up to 25/32 inch thick, covering standard solid wood and plywood inset doors in that range.
This hinge suits cabinet shops and installers fitting inset doors on either face-frame or frameless boxes. Inset work runs tighter than overlay work, and a hinge that holds its position reliably over repeated cycling matters when the reveal is the design. It is also a reasonable choice for furniture-style pieces and built-ins where a flush face is the intent. The 93 degree opening angle gives adequate access for a typical inset cabinet interior without the door swinging so wide it contacts an adjacent surface. For doors with a full overlay or half-overlay geometry, an overlay hinge is the right pick instead. A matching Sugatsune base plate is required and sold separately.
No. The hinge body requires a separate base plate that mounts to the cabinet. Use a matching Sugatsune plate; plates are brand-specific and a plate from another brand will not connect to this hinge.
A self-close spring pulls the door shut over the last few degrees of travel once it is released near closed. It is not soft-close: the door closes on its own but without a cushioned, damped feel. Inset doors benefit from self-close because the tight reveal leaves little room for a separate magnetic catch.
Yes. This hinge works on both face-frame and frameless cabinets. The cup bores into the door, and the base plate mounts to the cabinet side panel or face-frame stile depending on the construction.
Inset doors sit closer to the cabinet interior, and the geometry of an inset hinge produces a somewhat tighter swing than a standard overlay hinge. The 93 degree angle is correct for this configuration and gives workable access to a typical inset cabinet.
Specify the Olympia nickel inset hinge when the project calls for flush doors that close on their own and the hardware needs to stay consistent with a brushed nickel palette.
