Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Hettich M4 x 15mm Connecting Screw is a fine-thread machine screw designed to mount cabinet knobs, pulls, and other decorative hardware to door and drawer fronts. With a blunt point, nickel finish, and M4 thread sized for 5mm pre-bored holes, it seats cleanly into standard hardware fittings and threads firmly into tapped hardware bases without mar or misalignment.
Cabinet hardware installation demands a screw that threads into a tapped receiver without wandering, seats flush against the hardware base, and holds secure through daily use. The M4 thread is the European metric standard for decorative cabinet hardware, so this screw fits the pre-tapped holes in knobs, pulls, cup pulls, and bin pulls from Hettich and most other European hardware manufacturers. The 15mm length covers the combined thickness of a typical door or drawer front plus the hardware's backset, pulling the fitting tight without bottoming out short or protruding past the base.
The nickel finish matches the satin nickel and brushed chrome hardware tones common in contemporary kitchen, bath, and furniture cabinetry. Because the screw head is visible at the back of the cabinet door or drawer front after installation, a finish that coordinates with the hardware prevents an inconsistent look from mismatched metal tones. The fine M4 thread and blunt point are appropriate for metal-tapped hardware receivers; no pilot boring or thread-cutting is needed beyond the standard 5mm hardware hole.
Cabinet shops installing European hardware at volume rely on a connecting screw that matches their hardware spec exactly. A pack of 2000 supports a full production run without mid-job restocking, and having the correct M4 thread on hand eliminates the field substitution problems that arise when an 8-32 screw is tried in a metric-tapped fitting. Designers specifying Hettich hardware can call out part number 1054519 to ensure the installer receives the correct screw alongside the pull or knob. Contractors finishing a kitchen or bath remodel reach for the same screw when the hardware manufacturer's included fasteners run short.
No. M4 metric and 8-32 UNC are close in diameter but carry different thread pitches and are not interchangeable. M4 screws thread into M4-tapped hardware fittings; 8-32 screws thread into 8-32 tapped hardware. Using the wrong thread will strip the fitting or fail to engage. Match the screw thread to the hardware manufacturer's specification.
Yes. The blunt point is designed for pre-drilled or pre-tapped holes. Drive it into an existing 5mm hardware hole or a tapped hardware receiver. It is not a self-starting or self-tapping screw.
The product data does not specify a drive type for this connecting screw. Check the screw head directly or consult the Hettich product sheet for the correct bit size before driving at volume.
Nickel is a close visual match to satin nickel and brushed chrome finishes. It may read slightly warmer than polished chrome or cool stainless tones. For installations where the screw head is visible, check the finish against your hardware sample before committing to a full run.
Each box contains 2000 screws, sized for production cabinet shops and high-volume hardware installations.
Specify the Hettich M4 x 15mm Connecting Screw when the job calls for a fine-thread metric fastener that seats cleanly in standard European hardware fittings, finishes flush in a nickel tone, and keeps production moving with a full 2000-piece box on the bench.
Sold In: 1 Each