Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Hettich Quadro V6 470mm left-hand push-to-open undermount drawer slide delivers full-extension travel with a built-in mechanical opening mechanism, purpose-built for handle-less fronts in frameless cabinet construction. This is a single left-hand cabinet member; pair it with its right-hand counterpart to complete one drawer installation.
Push-to-open undermount slides find their best application in modern handle-less kitchen and bath cabinetry, where a clean, hardware-free front is the design goal. A press anywhere on the front ejects the drawer far enough to grip and pull; the cabinet interior stays completely concealed when the drawer is closed. At 470mm nominal length, this slide suits standard cabinet depths common in base and vanity runs. Full extension means nothing stays hidden at the back of the box, which matters in spice drawers, utensil storage, and anything pulled open frequently during a task.
This is a frameless-cabinet slide. It mounts directly to the flat interior panel, using the standard screw pattern — no rear mounting brackets or face-frame adapters are required. If your project involves face-frame construction, a different slide version is needed.
The Quadro V6 runs on ball bearings for consistent, smooth travel across its full extension range, even when the drawer is loaded near capacity. The steel members carry a zinc finish that holds up through years of daily cycling in dry indoor environments. Drawer side compatibility spans 1/2 inch to 5/8 inch thickness, covering both thinner shop-built boxes and standard 5/8 inch production sides. The push-to-open function is fully mechanical — no power supply, cables, or drive unit needed — so the installation is straightforward and there are no electrical components to service.
Cabinet shops running modern frameless lines with integrated push-to-open fronts are the primary buyer. Designers specifying handle-less kitchens specify the Quadro V6 for its clean look and reliable opening action. Contractors doing install work on pre-built frameless boxes will find the ball-bearing travel easy to set up and verify on site. Homeowners completing a renovation with handle-less cabinetry can source this slide when a replacement or upgrade is needed on a Quadro V6 installation — provided the cabinet is frameless and the drawer box is built to the Hettich specification for this runner.
Because this is the left-hand member only, shops ordering for a full run of drawers should confirm the quantity split between left-hand and right-hand units before the order is placed.
No. This is the left-hand member only. One left-hand and one right-hand unit are required to complete a single drawer installation.
The Quadro V6 listed here carries a push-to-open mechanism. Soft-close behavior on Hettich Quadro runners depends on the specific variant; confirm the closing motion of your slide series before specifying both functions together on the same drawer.
No. This version is designed for frameless construction. Face-frame installations require rear mounting brackets or a face-frame-specific slide version.
Undermount slides require the drawer box to be built to the manufacturer's nominal length specification. Build the box to Hettich's published dimension for the 470mm Quadro V6 runner, including any required rear notch and locking-device drilling.
Yes. Push-to-open mechanisms need the drawer front set with the manufacturer's specified gap so the press has travel to trigger the ejector. Consult Hettich's installation documentation for the Quadro V6 front gap dimension before setting the front.
When the design calls for a clean, handle-less drawer in a frameless cabinet, the Quadro V6 left-hand push-to-open slide delivers the full-extension travel and reliable opening action to back it up — order both hands to put it to work.
Sold In: 1 Each