Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Würth #10 x 2-1/2" truss head installation screw is a coarse-thread fastener designed for cabinet installation, millwork attachment, and interior finish work where a low-profile head with a wide bearing surface is the right call. The truss head sits flush against the surface without requiring a countersink, and the Recex drive accepts either a #2 Phillips or a #3 square bit so installers can use whatever is already on the belt.
Installation screws are the workhorses of cabinet hanging and millwork attachment. This #10 x 2-1/2" length reaches through a finished panel and into wall framing or a cabinet substrate with enough thread engagement to hold. The truss head's wide, flat underside bears against the surface rather than pulling into it, which matters when the material behind the fastener head is a finished panel face or a thin backing. Cabinet installers hanging upper boxes, attaching fillers, or securing valances reach for this profile because it holds without telegraphing through the material.
The needle point is well matched to light-gauge materials and finished surfaces where a sharp self-starting entry with minimal distortion is preferred. For installations directly into wall studs or solid blocking, a pre-drilled pilot in the panel keeps the entry clean and reduces any chance of surface movement near the head.
The zinc coating on the shank provides standard indoor corrosion resistance suited to the dry, climate-controlled environments where cabinet installation happens. The white head finish blends against painted cabinet interiors, white melamine, and light-colored panels so the fastener head draws less attention after installation. These screws are for interior work; for any application with moisture exposure or outdoor conditions, a coating rated for that environment is the correct choice.
The Recex recess is a combination Phillips and square design. A #2 Phillips driver works in the same recess as a #3 square bit. On a busy install, that means fewer bit changes and less downtime when a crew member reaches for the driver already in hand. The square recess is designed to hold the screw on a correctly sized bit for easier one-handed placement, which adds up across a full day of hanging cabinets.
This screw is a practical choice for cabinet shops doing their own installs, finish carpenters hanging millwork and built-ins, and production crews that need a reliable fastener in volume. The 1,000-piece box supports a full job without repeated restocking. The combination of truss head, white head finish, coarse thread, and Recex drive covers the most common interior installation scenarios without needing multiple SKUs on the truck.
The Recex combination recess accepts both a #2 Phillips bit and a #3 square bit in the same recess, so either driver works for installation.
The truss head has a wider, lower-profile bearing surface than a standard pan head, which distributes clamping load over a larger area. Unlike a flat head, it does not require a countersink, making it faster to use when driving into a finished panel or cabinet back.
The white head finish is primarily cosmetic. It blends the fastener head against white-painted cabinet interiors, white melamine, and light-colored panels so the head is less visible after installation. Corrosion protection comes from the zinc coating on the shank.
This screw carries a zinc finish suited for dry indoor environments. For applications with moisture exposure, high humidity, or outdoor conditions, a screw with a coating rated for that environment is the right choice.
The needle point allows the screw to pierce material with minimal entry force, which is useful near finished surfaces or when working with light-gauge materials where a coarser point might distort the entry area.
With a truss head that bears wide, a combination drive that works with the bit already in hand, and 1,000 screws to the box, this Würth installation screw is built to get cabinets on the wall and millwork in place without slowing the crew down.
Sold In: 1000 Each