Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Rinco-Matic clip is a fixing and balancing clip for the SYMA32 profile handle system, designed specifically for 45-degree inglete corner conditions in a handleless cabinet run.
A standard handleless run meets walls and other runs at square ends. An inglete joint is the exception: a 45-degree mitered corner where two profile lengths meet at an angle rather than butting squarely. At that junction the standard fixing clip geometry does not seat correctly, and this angled clip is the part that does. Without the right clip at an inglete corner, the profile can shift out of alignment or leave the joint unsupported during installation.
Rinco-Matic builds the SYMA range as a family of discrete parts, each dimensioned to its own profile cross-section and its own installation condition. The SYMA32 and SYMA14 are different sizes, and each takes its own clips, caps, and corners. This clip is made for the SYMA32. Using a clip from a different SYMA size, or from another supplier's system entirely, will not produce a correct fit at the inglete corner.
This clip suits a cabinetmaker or installer running Rinco-Matic SYMA32 profiles where a 45-degree mitered corner junction is part of the layout. Island corners, angled peninsula runs, and diagonal accent sections are the typical conditions that call for an inglete clip rather than the standard square-end fixing. If the run has no angled junctions, the standard SYMA32 clip is the appropriate part.
No. Each SYMA size takes its own components. This clip is made for the SYMA32 series only.
An inglete is a 45-degree mitered junction where two profile lengths meet at an angle. It is different from a square butt end or a perpendicular inner and outer corner, and it requires a clip made to that angle.
Yes. The product includes the clip and screw together, as the description states.
No. The inglete clip is specific to 45-degree corner junctions. If your run has only square ends, you need the standard SYMA32 clip instead.
For a SYMA32 run that turns at 45 degrees, this is the clip that holds the corner in place and keeps the profile seated through installation.
Sold In: 1 Set