Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Blum STANDARD 230 epoxy-coated Euro slide is an 18 inch, white, 3/4-extension roller slide built for production cabinet work. Its white epoxy finish is designed to disappear against white melamine and painted cabinet interiors, so the hardware blends in rather than standing out when the drawer is open.
The white finish makes this slide the right call for kitchen, bath, and closet cabinetry built with white melamine interiors. When the drawer is pulled open, a white slide against a white panel is almost invisible — a zinc or almond slide is not. It is equally at home in painted-interior frameless cases and in face-frame builds where a clean interior appearance matters to the homeowner or designer. Closet organizers, vanity cabinets, and bedroom casework with white interiors are all strong fits.
At 18 inches, this length suits standard base and vanity cabinets with 18 inch or shallower interior depths. For deeper runs, the STANDARD 230 series is available in additional lengths.
The white epoxy powder coat is baked over steel, producing a finish that holds its color through repeated use without chipping or fading under normal cabinet conditions. This is a finish and color choice built for interior aesthetics — the epoxy blends, it does not protect against moisture, so keep this slide in dry, indoor cabinet work.
The self-closing ramp is a mechanical feature: push the drawer within range and the ramp pulls it home with a positive close. This is self-close, not soft-close — the close is direct and undamped. If a slowed, silent landing is required, a damped soft-close slide is the appropriate choice instead.
Cabinet shops running white kitchen and bath programs reach for this slide when the interior finish spec calls for white hardware throughout. Designers specifying painted or white melamine interiors include it to keep the hardware consistent. Contractors repairing or refacing white-interior casework use it as a direct match for existing Blum STANDARD 230 installations. The non-handed format means no sorting on the job — pull from the box and install on either side.
Self-close. The Blum STANDARD 230 uses a mechanical closing ramp that pulls the drawer shut with a positive close once it is pushed into the capture zone. There is no damper — the close is not slowed. For a damped, quiet landing, you would need a soft-close slide.
No. This slide is non-handed, so the same part installs on either side of the drawer without sorting or special ordering.
The slide length should match your cabinet's interior depth. An 18 inch slide is well suited to standard base and vanity cabinets built at 18 inches deep or slightly deeper. Measure the interior depth before ordering.
This is a 3/4-extension slide. At full open, the rear portion of the drawer stays inside the cabinet — the entire drawer interior is not accessible from the front. If full rear access is required, a full-extension slide is the right spec.
Yes, but face-frame installs typically require rear mounting sockets to support the back of the slide. Those sockets are series-specific to the STANDARD 230 and sold separately — plan them into your order alongside the slides.
The Blum STANDARD 230 in white gives cabinet shops a reliable, visually matched slide for white-interior casework — consistent self-close behavior, a non-handed format that speeds installation, and a finish that blends rather than shows.
Sold In: 1 Set