Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The US Futaba DynaSlide 10 inch over-travel drawer slide is a ball-bearing, side-mount slide built for installations where the drawer must travel past the cabinet face to fully clear a countertop overhang, face frame, or obstruction. Sold as a non-handed pair in a zinc finish, it suits shops, furniture makers, and contractors who need reliable over-travel performance at a 100 lb load rating.
A standard full-extension slide brings the drawer to the cabinet face — which is enough for most kitchen and furniture drawers. Over-travel goes further. When a countertop overhangs the cabinet face by an inch or more, or when a thick face frame creates a lip the drawer box would otherwise collide with, over-travel extension lets the drawer clear that obstruction entirely. The DynaSlide's over-travel geometry is also useful on workbenches and shop carts where a drawer must open past an adjacent structure. At 10 inches, this slide suits shallow drawers: spice pull-outs, small tool drawers, and desk pedestals where interior depth is limited but clearance past the front is still required.
The DynaSlide is built from steel with a zinc finish — the workhorse material combination for side-mount ball-bearing slides in dry, indoor cabinetry. Zinc plating protects the steel members through years of regular use without adding unnecessary cost. This is an indoor slide; it is not rated for wet, washdown, or exterior environments. The ball-bearing system runs in formed steel raceways, keeping motion smooth and precise even when the drawer is loaded near the rated capacity.
Cabinet shops building shallow drawer banks in face-frame construction are the most common buyer: the 10 inch length fits shallow cabinet depths, and over-travel solves the clearance problem the face frame creates without requiring a custom solution. Furniture builders fitting small desk pedestals or nightstand drawers that sit under an overhanging top reach for this slide for the same reason. The hold-in detent also makes it a practical choice on shop carts or rolling workstations where drawers need to stay put between uses.
Over-travel on this slide extends the drawer member past the nominal slide length, typically by about one inch beyond full extension — enough to clear most countertop overhangs and standard face frames. The exact over-travel distance is not published in the source data; if your overhang exceeds one inch, verify the specific travel figure before ordering.
The DynaSlide 10 inch over-travel slide is sold as a pair — one pair installs one drawer.
Standard side-mount ball-bearing slides require 1/2 inch of clearance per side between the drawer box and the cabinet interior. Build the drawer box 1 inch narrower than the cabinet opening to accommodate both slides.
No. The hold-in detent is a position catch: it keeps the drawer closed once you push it shut, but it does not pull the drawer in or damp the closing motion. Push the drawer to the closed position and the detent holds it there.
Yes — and face-frame cabinets are one of the primary reasons to choose an over-travel slide. The face frame creates a lip that a standard slide's drawer box can catch on; over-travel extension clears it. Rear mounting brackets may be needed to support the back of the slide in face-frame construction; confirm your cabinet's interior depth allows for the slide and any rear hardware.
When the cabinet is shallow and the front gets in the way, the DynaSlide over-travel design solves the clearance problem without a workaround — giving the drawer the travel it needs in the space that's available.
Sold In: 8000 Set
