Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Grass #10 x 3/4-inch round head hinge and drawer slide installation screw is designed specifically for attaching European-style hinges and drawer slides to cabinet panels. Manufactured by Grass America and finished in Nickel, this screw pairs naturally with Grass hardware and works wherever a #10 round head mounting screw is called for in cabinet assembly.
Hinge mounting plates and drawer slide brackets are pre-bored for a specific screw gauge, and using the correct screw matters. The #10 gauge shank fills the mounting hole cleanly so the hardware does not shift before the screw is fully seated. The round head bears flat against the mounting plate rather than pulling through it, which is the right behavior for surface-mount hardware attachment. The 3/4-inch length is matched to cabinet panel stock: long enough for solid holding power without punching through the back face of a standard panel.
The Nickel finish gives the screw head a clean, consistent look alongside Nickel-finished Grass hinges and slides. Because these screws are inside the cabinet and hidden by the hardware they mount, finish serves primarily as a visual match rather than a corrosion barrier. This screw is intended for dry indoor cabinetry. For any application with moisture exposure, confirm that the finish is appropriate for the environment before installing.
Cabinet shops assembling Grass-hardware kitchens and bath installations will find the 500-piece box a practical shop quantity. Installers working on site who want a dedicated mounting screw that matches the hardware finish can pull from the same box without sorting. The #10 round head Phillips configuration is also a standard fit for many non-Grass European hinges and drawer slides that share the same pre-bored mounting plate geometry, so the screw serves a wider range of hardware than the Grass line alone.
Hardware mounting plates are designed with a flat countersink or a surface bearing area sized for a round or pan head. A flat or bugle head would not seat correctly against that surface and could cause the hardware to sit proud or at an angle. The round head bears evenly against the plate for a flush, stable mount.
Many European-style hinges and drawer slides from other manufacturers share the same pre-bored mounting hole geometry and call for a #10 screw in the same length range. Check the hardware manufacturer's installation instructions to confirm the gauge and length before substituting.
The sharp point and coarse thread are designed to self-start in typical cabinet panel material without pre-drilling in most cases. In very dense hardwood face frames or when driving close to an edge, a pilot hole helps prevent splitting.
These are designed for dry indoor cabinetry. For installations in high-humidity environments such as exterior cabinets or outdoor kitchens, confirm the finish rating with your hardware supplier before specifying.
Specifying the correct screw for hinge and drawer slide mounting is a small decision with a noticeable effect on how the hardware performs and how the finished cabinet looks. This Grass #10 x 3/4-inch round head Phillips screw gives shops and installers a purpose-built option in a quantity that supports production work.
Sold In: 500 Each