Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This right-hand plastic rear mounting socket from Bainbridge Manufacturing gives the back end of a KV epoxy drawer slide a fixed bearing point inside the cabinet, completing the support needed for a stable, level install in face-frame and similar cabinet constructions where the slide's rear cannot fasten directly to a cabinet side.
The rear mounting socket solves a specific installation problem: in face-frame cabinets, or any cabinet where the back of the drawer slide cannot screw directly to a flat panel, the slide's rear end needs a dedicated cradle to hold it at the correct height and alignment. Without it, the back of the slide droops or shifts, and the drawer runs rough or racks side to side. This socket anchors the rear of the KV epoxy slide at the right-side position, holding the member firm so the drawer travels straight from front to back. It is the finishing piece that turns a partially installed slide into a fully supported one.
Molded in plastic, this socket keeps weight low and eliminates any rust concern inside the cabinet. At 2-1/8 in deep, 7/8 in tall, and 3/8 in wide, it sits close to the cabinet wall without eating into usable drawer clearance. Screw-on attachment means no special hardware or press-in tools — drive two screws, and the socket is set. Plastic is the right material here: these sockets live entirely inside finished cabinets where corrosion resistance matters more than raw strength, and the slide itself carries the load.
Cabinet installers and shop builders running KV epoxy slides in face-frame cabinets are the primary buyers. If your slide layout requires rear support and you are working the right side of the cabinet, this is the specific socket for that position. Renovation contractors replacing existing epoxy slide hardware will also find it useful when the original socket is missing or damaged. Order the left-hand version alongside this right-hand socket to complete a drawer's rear support in one pass.
The SAP reference indicates compatibility with the KV 1282 and KV 94 epoxy slide series. Confirm your slide model against the socket's mounting geometry before ordering if you are working with a different KV epoxy series.
One socket supports one slide's rear end. A single drawer uses two slides, so a complete rear support requires one right-hand socket and one left-hand socket — each sold separately.
The socket uses standard screw-on mounting through its body; the source data does not specify a screw size. Use a screw that suits your cabinet panel material and clears the socket's 3/8 in width without splitting the panel.
It is most commonly needed in face-frame cabinets, where the slide's rear end has no direct panel to fasten to. Any cabinet construction that leaves the back of the slide unsupported can use this socket to complete the mount.
A drawer slide is only as steady as its weakest mount point, and the rear is where epoxy slides most often lose support. This right-hand socket closes that gap cleanly, so the slide runs true and the drawer lasts the life of the cabinet.
Sold In: 1 Each