Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This is the 22-1/2 inch (570mm nominal) Grass 6600 series almond epoxy-coated cabinet member, a side-mount roller slide component for cabinet shops and woodworkers matching hardware to almond or cream melamine interiors. The 6600 is Grass America's side-mount roller slide, made in the USA, and this member is sold individually so production shops can order exactly the count they need.
Buying slide components by the member rather than as pre-paired sets gives a cabinet shop precise control over inventory. If a run calls for a specific count of cabinet members in almond, ordering them individually avoids leftover pieces. This 6600 cabinet member pairs with the matching 6600 drawer members to complete one working side of the drawer. One drawer requires one cabinet member per side and one drawer member per side, so four members in total per drawer. Pair 6600 members only with other 6600 series members — 6600 and 6610 components are series-specific and do not interchange.
The almond epoxy powder-coat is a baked finish over formed steel, not a structural upgrade — its job is color matching. Where white epoxy reads clean against white interiors, almond reads warm against the slightly off-white tones common in traditional and transitional cabinetry, natural wood veneer panels, and almond-finished drawer boxes. The roller bearings run on nylon wheels in the steel channel. Motion Technology for this member is Standard, meaning no self-closing ramp and no soft-close damper: the drawer rolls freely and stays where it is positioned. If a self-closing action is needed, specify the self-closing 6600 members from the same series.
This member suits cabinet shops standardized on almond-interior boxes, renovation contractors replacing damaged halves without swapping entire sets, and designers specifying hardware to coordinate with almond or warm cream melamine casework. At 22-1/2 inches it fits standard kitchen base-cabinet drawer depths. Build the drawer box 1 inch narrower than the inside cabinet width — Grass's formula is drawer width equals inside cabinet width minus 25.4mm (1 inch) — and confirm the cabinet has clearance for the 570mm nominal member length.
This is a single cabinet member, not a set. To run one drawer, you need a cabinet member for each side and a drawer member for each side — four members per drawer total, all from the 6600 series.
The 6600 can be used in face-frame cabinets, but you will need the matching Grass 6600 series rear mounting sockets to support the back end of the slide. Those sockets are sold separately and are series-specific.
Yes. This member's motion is Standard, meaning there is no self-closing ramp or damper. The drawer rolls freely and stays where it stops. If you want the self-closing ramp, look for the self-close version in the 6600 series.
The Grass 6600 series suits drawer material from 1/2 inch (12.7mm) to 3/4 inch (19mm) thick — the full range of typical plywood and solid-wood drawer sides.
No. The 6600 cabinet member works only with 6600 drawer members. The 6610 is a different bottom-mount series with different geometry; mixing the two will not produce a working slide.
For shops building to an almond interior and ordering members in the exact count they need, this Grass 6600 series 22-1/2 inch almond cabinet member keeps the color match tight and the parts inventory clean.
Sold In: 100 Each
