Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Sugatsune ESR-10 is a 26 inch, full-extension ball-bearing side-mount drawer slide in 304 stainless steel, rated 440 lb per pair with a hold-in anti-rebound detent. It is built for commercial kitchens, food-processing environments, healthcare carts, marine cabinetry, and any application where plated steel would corrode or fail inspection.
The ESR-10's combination of 304 stainless, 440 lb capacity, and hold-in detent targets environments that eat ordinary hardware. In a commercial kitchen, daily washdown cycles and steam exposure will degrade zinc-plated slides over months; stainless stays clean and functional. On a healthcare cart or lab bench, the anti-rebound detent keeps drawers from drifting open during transit. In a marine galley or outdoor equipment cabinet, salt air and condensation demand a material that holds up without protective coatings. The 440 lb class also opens this slide to heavy equipment drawers, server pull-outs, and industrial casework that would overwhelm a standard 100 lb kitchen slide.
The ESR-10 series is constructed from 304 stainless steel throughout. That grade resists corrosion in food-service and wet-service environments far better than electroplated steel finishes, and it meets the surface-material expectations of commercial kitchen and healthcare inspectors. The stainless here is the structural material, not a coating — the slide does not depend on a plating layer that can chip, wear, or lift. Ball bearings run in full-length stainless raceways, keeping movement smooth and load transfer even through the full 26 inch travel. This is a standard-motion slide with a hold-in anti-rebound detent: the drawer stays shut until pulled and does not bounce back from a firm close, but there is no soft-close damping.
Fabricators building commercial kitchen casework, millwork shops fitting out healthcare and laboratory spaces, and marine cabinet makers will find the ESR-10 sized for the loads and environments their customers actually face. At 440 lb per pair, it also suits heavy-duty shop and industrial drawers where a stainless finish is required for sanitation or corrosion reasons. Residential specifiers who want stainless for a high-end kitchen or outdoor kitchen should confirm that 304 stainless meets their corrosion requirements — it performs well in most residential wet environments, and for continuous coastal or salt-spray exposure, verify the grade requirement before specifying.
Yes. The SAP description and series data cite 304 stainless steel construction — this is the alloy itself, not a stainless-look plating over a steel substrate.
No. The hold-in anti-rebound detent keeps the drawer in the closed position and prevents it from bouncing back open, but it releases with a normal pull. It is not a keyed or lever-released lock.
The 440 lb rating is per pair of slides as listed in the product attributes. Do not double the figure — both slides together carry 440 lb.
No. The ESR-10 is a standard-motion slide with a hold-in anti-rebound detent. If you need damped soft-close closing, look at the ESR-DC or ESR-SC series instead.
The ESR-10 is a side-mount ball-bearing slide. Confirm the required side clearance per side against the Sugatsune ESR-10 installation specification before sizing your drawer box.
When the job calls for a heavy-duty slide that holds up to washdown, chemical exposure, or corrosive air — not just for a season but for the life of the installation — the ESR-10 delivers the material, the capacity, and the detent behavior to keep the drawer doing its job.
Sold In: 1 Each