Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Kreg #7 x 1-inch coarse-thread pocket-hole and face frame screw is built for production joinery in softwood, plywood, MDF, and other sheet goods. The modified pan head seats flat against the pocket wall and pulls joints tight, while the Type 17 auger point and square drive keep installation moving without interruption.
At 1 inch, this screw is the go-to length for 3/4-inch stock joined at a pocket angle, the most common dimension in cabinet face frame construction, drawer box assembly, and cabinet carcass work using sheet goods. Coarse thread is the correct choice when the material is softwood, pine, poplar, plywood, MDF, melamine-faced particleboard, or any other low-to-medium density panel. The thread spacing bites into the fiber matrix of those materials and resists pull-out under the stress of a loaded shelf, a cycling drawer, or a door swinging on its hinges. Hardwood face frames in maple, oak, or cherry call for fine thread instead; the coarse thread on this screw is not the right fit for those species.
The modified pan head keeps its bearing surface flat rather than tapered, so it seats squarely on the pocket ramp and draws the joint closed evenly. There is no wedging action to push the pieces apart as the screw seats. The #2 square drive transfers torque efficiently and holds the bit in the recess with less tendency to slip than a cross-point drive under the same load, which matters when the bit is buried inside a pocket hole and repositioning is awkward. The Type 17 auger point carries a small flute near the tip that cuts wood fiber and clears chips as the screw drives, reducing the effort needed to start into the mating piece and lowering the chance of blowout on the back face of thin stock.
A box of 1,200 is sized for shops that run pocket-hole joinery consistently, not occasionally. Cabinet shops building softwood or sheet-good face frames, framers assembling stud-grade lumber, and finish carpenters joining trim and casing components all go through this size at volume. A single kitchen's worth of face frames can consume several dozen screws; a full production run consumes several hundred. Keeping a full box on the shelf prevents the kind of mid-job interruption that stalls an install or a shop run. This screw is for interior dry work; it is not rated for exterior or pressure-treated lumber applications.
Yes. Coarse thread is the correct thread form for MDF, melamine, and particleboard. The wide thread spacing engages the fiber matrix of those materials better than fine thread does, and the modified pan head seats cleanly against the pocket wall without crumbling the material around the joint.
Coarse thread is designed for low-to-medium density materials where the wider spacing captures enough fiber volume for strong pull-out resistance. In dense hardwoods like maple or oak, the same coarse thread can split the grain rather than grip it. Fine thread is the correct choice for hardwood face frames.
This screw uses a #2 square drive bit. Using a correctly sized bit is important for bit retention and clean torque transfer; an off-spec or worn bit reduces both.
No. The zinc finish on this screw is suited to dry indoor conditions. Exterior or pressure-treated applications require a screw with a coating rated for those environments.
The 1-inch length is sized for 3/4-inch material joined at a pocket angle. Thicker stock or different joint configurations may call for a longer screw; consult the pocket-hole jig manufacturer's screw selection chart for the specific material thickness being joined.
When the material is softwood, plywood, or an engineered panel and the joint is a pocket hole, this Kreg 1-inch coarse-thread screw delivers the thread engagement, head geometry, and drive control to keep assembly fast and the joint solid.
Sold In: 1 Box