Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Quickscrews #14 x 2-1/2 inch washer head installation screw is a large-gauge fastener designed for securing cabinets to wall studs, mounting heavy cabinet assemblies, and similar installation work where a broad bearing head and strong thread engagement are needed. Packed 1,500 to the box, it is sized for shops and installers running volume cabinet work.
The #14 gauge and 2-1/2 inch length make this screw a natural fit for securing upper and base cabinets to wood wall studs, where the screw needs to pass through a cabinet back panel and reach well into the stud. The washer head bears flat against the cabinet interior surface without countersinking, which is typical practice when fastening into the hanging rail or back panel of a cabinet box. The Hi-Lo thread engages both denser solid wood and softer engineered panel materials with lower driving resistance than a standard coarse thread at the same gauge, which matters when an installer is driving dozens of screws across a full kitchen or bath layout. The sharp point self-starts without a separate pilot step, keeping the pace of a production install moving.
The zinc finish on this screw provides standard galvanic protection appropriate for dry interior environments. Cabinet installation in kitchens, baths, laundry rooms, and similar indoor spaces falls well within that range. This is an interior installation screw. For any application in a wet, exterior, or treated-lumber environment, a corrosion-resistant coating rated for that exposure is the right choice instead.
Cabinet installers working through multi-cabinet kitchen or bath projects will get the most from this box. The 1,500-count pack matches the consumption rate of a busy installation crew or a cabinet shop that pre-stages hardware before jobs. The #14 gauge is on the larger end for installation screws, so it is best suited for fastening into solid wood studs or thick solid-wood hanging rails rather than thin panel material where a smaller gauge would be a better fit. The #3 Phillips drive is consistent with impact driver bits already on most installation rigs, so no special tooling is needed.
The washer head sits flat against the surface without countersinking, distributing the clamping load over a wider area than a flat or pan head. On cabinet installation work, this keeps the screw bearing firmly against the hanging rail or cabinet back without pulling through or requiring a pre-drilled countersink.
Hi-Lo thread alternates a tall, sharp high thread with a shorter low thread. The high thread cuts deep for pull-out resistance while the low thread provides stability between them. The result is lower driving torque than a full-height coarse thread at the same gauge, which reduces fatigue during repetitive driving in a multi-cabinet install.
The sharp point self-starts in wood, so a pilot hole is not required for most typical stud and rail fastening. In very hard or brittle wood, a pilot hole may reduce the risk of splitting near the edge of the stock.
No. The zinc finish is rated for dry indoor environments. For outdoor, high-humidity, or treated-lumber applications, choose a screw with a corrosion-resistant coating designed for that exposure level.
It uses a #3 Phillips bit, which matches the larger head size of a #14 gauge screw. A #2 Phillips is too small for this gauge and will cam out.
When the job is hanging cabinets and the priority is a screw that drives fast, holds firmly into solid wood studs, and comes in a quantity that keeps up with a full install, this #14 x 2-1/2 inch washer head installation screw is the right tool for the box.
Sold In: 1 Each