Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Tenn-Tex #7 x 2" washer head installation screw is a coarse-thread fastener built for cabinet installation, panel assembly, and hardware mounting where a broad bearing head and a flexible drive choice keep the job moving. The combo drive accepts either a #2 Phillips or a #2 square bit, and the Type 17 auger point starts cleanly in wood without a pilot hole in most applications.
Cabinet installers reach for this screw when securing cabinet boxes to wall studs, joining adjacent cabinet units through the face frame stiles, or mounting hardware backing blocks inside a carcass. The 2-inch length gives enough thread engagement for fastening through a cabinet side panel or nailer into wood framing behind. The washer head sits against the material surface and pulls components tight without countersinking, which suits utility fastening inside a cabinet box or in areas that will not be seen in the finished installation. Coarse thread holds well in plywood, solid wood, and pine framing, the materials an installer encounters most on a residential or light commercial cabinet job.
The combo recess accepts a #2 Phillips and a #2 square bit in the same opening. Square drive is designed to hold the screw on a correctly sized bit for one-handed placement, which helps when working in tight cabinet interiors or overhead. Phillips remains the most common bit on any job site, so the combination covers both scenarios without carrying two different screws. The washer head provides a broad, flat bearing surface that distributes clamping force across a larger area than a standard pan head, which matters in particleboard, plywood, and softer materials where a smaller head can pull through under load. No nibs are present on this head, so a countersink is not milled during seating — the head bears flat against the surface.
Cabinet installers, finish carpenters, and shop assemblers working on residential and light commercial cabinetry will find this screw well matched to the tasks that come up repeatedly during an install: attaching cabinet boxes to walls, connecting unit runs together, and fastening hardware backing in wood-based panel materials. The 400-piece box is sized for a multi-cabinet project or a regular shop supply rather than a small job lot. Keeping a box on the truck or at the bench means the right screw is available when the job calls for a broad-head, flexible-drive fastener in a 2-inch coarse-thread size.
The combo recess accepts a #2 Phillips bit and a #2 square bit in the same opening. Both are standard sizes found in most driver sets, so no specialty bit is required.
No. This screw has no nibs on the underside of the head, so it bears flat against the material surface rather than milling its own countersink. It is designed to sit on top of the material, not flush with it.
The 2-inch length and coarse thread are well suited for fastening through a cabinet nailer or side panel into wood framing. Match length to the total material thickness plus required embedment for your specific application.
The Type 17 auger point is designed to start without a pilot hole in most wood and wood-based panel materials. In thin stock or close to an edge, a pilot hole reduces the risk of splitting.
Each box contains 400 screws.
When cabinet installation day comes and the fastener list includes a broad-head, dual-drive screw that works in wood framing and panel materials alike, the Tenn-Tex #7 x 2" washer head installation screw is a straightforward choice that covers the most common scenarios in one box.
Sold In: 1 Bag