Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Salice Series 100 hinge delivers full overlay door positioning with a dowelled cup mount designed for production CNC environments, on both frameless and face-frame cabinets. The nickel-plated finish coordinates cleanly with the visible hardware runs where this hinge occasionally shows at the cup.
This hinge is aimed at cabinet shops and CNC operations where doors are bored with dowel holes rather than driven with cup screws. The cup's pre-attached dowels press directly into the bored door holes, eliminating the screw-driving step at the door and keeping the line moving. The 35mm cup seats in a standard bore, the 45mm boring pattern matches the most common production setup, and the shallow 8mm cup depth makes it usable on thinner door stock where a deeper cup would break through the face. The hinge arm clips to a Salice base plate mounted on the cabinet side, ordered separately. That plate is Salice-specific and must be matched to your cabinet construction and desired overlay.
The hinge is steel with a nickel-plated finish. For a full cabinet run, the nickel finish carries through to the cup area and arm, so when the door swings open, the hardware reads consistently with satin or brushed nickel pulls. Series 100 sits at the lighter end of the Salice line, designed for doors that fall within standard weight range for the series. The self-close spring is a mechanical pull, not a damped slow-close: the door closes on its own but does not cushion the final contact. If the project calls for a quiet, damped close, the Silentia+ soft-close version of this series is the right swap.
Reach for this hinge on full overlay doors in frameless or face-frame cabinets being produced in a shop where CNC dowel boring is part of the workflow. It is a natural fit for production runs, multi-unit residential work, and remodels where the installer wants a fast, consistent door mount. For doors heavier than the Series 100 load table allows, move up to the Series 200. For applications where the spring pull is not wanted, a free-swinging version handles push-to-open setups.
No. The hinge arm clips to a base plate that mounts to the cabinet, and that plate is sold separately. Use a Salice plate matched to your cabinet type and overlay. Plates are Salice-specific and are not interchangeable with other brands.
The cup carries pre-attached dowels that press into bored holes in the door rather than screwing in. This removes the cup-screw driving step, which is the advantage in CNC and production shops where dowel holes are already in the boring program.
No. This is a self-close hinge: a spring draws the door shut over the last few degrees. It does not slow or cushion the close. For a damped, quiet close on the same overlay and cabinet type, look at the Silentia+ soft-close version in the Salice Series 200.
The shallow cup is intentional. An 8mm depth works on thinner door panels where a standard 13mm cup would bore too close to the face. If your doors are standard thickness and depth is not a constraint, confirm the shallow cup still seats fully in your bore before ordering in volume.
This hinge is for shops that want a fast, dowelled door mount with a nickel finish that holds up across the full hardware run, on full overlay doors in frameless or face-frame cabinets.
Sold In: 1 Each